Water hardness in Fort Washington, MD

Water in Fort Washington is soft, with a median of 52 mg/L (3.1 grains per gallon) across 9 monitoring sites within 10 miles.

about the same as the Maryland median (56 mg/L) 90th hardest of 121 Maryland towns Population 23,717 (2010)
52mg/L
3.1 grains per gallon
Soft

Fort Washington tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 52 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 3.1 gpg (2.9 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites9
Lab samples10
Sample years2000–2016
Middle 50% of sites4–77 mg/L
Groundwater (wells, springs)4 mg/L · 5 sites
Surface water (rivers, lakes)53 mg/L · 4 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Fort Washington

Prefilled with Fort Washington's measured local hardness of 52 mg/L (3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Fort Washington tap water

Fort Washington is served by more than one water system. These systems supply ZIP codes in Fort Washington and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Fort Washington

Water systemPFAS detectedHighest PFOA / PFOSTested
Washington Suburban Sanitary Commission
serves over 10,000 people
PFPeA, PFHxA — Mar 2023 – Jun 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Fort Washington

Fort Washington is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Fort Washington

Water systemService linesTotal
Washington Suburban Sanitary Commission8 lead · 1,277 galvanized · 57,121 unknown58,406

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Fort Washington drinking water violations

Fort Washington is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Fort Washington

Water systemHealth-based violationsMonitoring/reporting
Washington Suburban Sanitary CommissionNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Fort Washington

SiteTypeDistanceMedianSamplesYears
HUNTERS MILL BRANCH TRIBUTARY NEAR FRIENDLY, MD
USGS Maryland Water Science Center
Stream 2.4 mi46 mg/L12000
PG Fb 63
USGS Maryland Water Science Center
Well 4 mi1 mg/L12016
PEA HILL BRANCH AT CAMP SPRINGS, MD
USGS Maryland Water Science Center
Stream 4 mi52 mg/L12000
CH Be 72
USGS Maryland Water Science Center
Well 5.7 mi1 mg/L12007
CH Be 73
USGS Maryland Water Science Center
Well 5.7 mi4 mg/L12013
PAYNES BRANCH AT CLINTON, MD
USGS Maryland Water Science Center
Stream 7 mi53 mg/L12000

Water hardness in towns near Fort Washington

TownDistanceMedianClass
Accokeek4 mi 26 mg/LSoft
Oxon Hill4 mi 52 mg/LSoft
Clinton6 mi 56 mg/LSoft
Glassmanor6 mi 77 mg/LModerately hard
Camp Springs7 mi 68 mg/LModerately hard
Hillcrest Heights8 mi 77 mg/LModerately hard
Suitland9 mi 77 mg/LModerately hard
Waldorf10 mi 29 mg/LSoft
Rosaryville10 mi 120 mg/LModerately hard
Forestville11 mi 77 mg/LModerately hard

Prince George's County

Fort Washington is in Prince George's County, where the median is 60 mg/L (moderately hard) across 27 sites.

See all of Prince George's County →

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next