Water hardness in Beltsville, MD

Water in Beltsville is soft, with a median of 54 mg/L (3.1 grains per gallon) across 18 monitoring sites within 10 miles.

about the same as the Maryland median (56 mg/L) 87th hardest of 121 Maryland towns Population 16,772 (2010)
54mg/L
3.1 grains per gallon
Soft

Beltsville tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 54 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 3.1 gpg (3 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites18
Lab samples28
Sample years2000–2019
Middle 50% of sites13–96 mg/L
Groundwater (wells, springs)16 mg/L · 13 sites
Surface water (rivers, lakes)74 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Beltsville

Prefilled with Beltsville's measured local hardness of 54 mg/L (3.2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Beltsville tap water

Beltsville is served by more than one water system. These systems supply ZIP codes in Beltsville and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Beltsville

Water systemPFAS detectedHighest PFOA / PFOSTested
Washington Suburban Sanitary Commission
serves over 10,000 people
PFPeA, PFHxA — Mar 2023 – Jun 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Beltsville

Beltsville is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Beltsville

Water systemService linesTotal
Washington Suburban Sanitary Commission8 lead · 1,277 galvanized · 57,121 unknown58,406

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Beltsville drinking water violations

Beltsville is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Beltsville

Water systemHealth-based violationsMonitoring/reporting
Washington Suburban Sanitary CommissionNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Beltsville

SiteTypeDistanceMedianSamplesYears
PG Cd 25
USGS Maryland Water Science Center
Well 4.8 mi5 mg/L12016
PG Be 38
USGS Maryland Water Science Center
Well 5.2 mi7 mg/L12003
NORTHEAST BRANCH ANACOSTIA RIVER AT RIVERDALE, MD
USGS Maryland Water Science Center
Stream 5.5 mi60 mg/L12007
NORTHWEST BR ANACOSTIA RIVER NR HYATTSVILLE, MD
USGS Maryland Water Science Center
Stream 6.5 mi105 mg/L12007
PG Cc 31
USGS Maryland Water Science Center
Well 7 mi180 mg/L12003
BALD MILL BRANCH AT LANHAM, MD
USGS Maryland Water Science Center
Stream 7 mi103 mg/L12000

Water hardness in towns near Beltsville

TownDistanceMedianClass
Calverton2 mi 90 mg/LModerately hard
College Park3 mi 103 mg/LModerately hard
Fairland3 mi 60 mg/LModerately hard
White Oak4 mi 164 mg/LHard
Greenbelt4 mi 60 mg/LModerately hard
Adelphi4 mi 161 mg/LHard
South Laurel4 mi 16 mg/LSoft
Langley Park5 mi 164 mg/LHard
Colesville5 mi 106 mg/LModerately hard
Laurel5 mi 24 mg/LSoft

Prince George's County

Beltsville is in Prince George's County, where the median is 60 mg/L (moderately hard) across 27 sites.

See all of Prince George's County →

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next