Water hardness in Laurel, MD

Water in Laurel is soft, with a median of 24 mg/L (1.4 grains per gallon) across 19 monitoring sites within 10 miles.

57% softer than the Maryland median (56 mg/L) 104th hardest of 121 Maryland towns Population 29,400
24mg/L
1.4 grains per gallon
Soft

Laurel tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 24 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1.4 gpg (1.3 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites19
Lab samples29
Sample years2000–2019
Middle 50% of sites9–66 mg/L
Groundwater (wells, springs)16 mg/L · 16 sites
Surface water (rivers, lakes)74 mg/L · 3 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Laurel

Prefilled with Laurel's measured local hardness of 24 mg/L (1.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Laurel tap water

Laurel is served by more than one water system. These systems supply ZIP codes in Laurel and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Laurel

Water systemPFAS detectedHighest PFOA / PFOSTested
Washington Suburban Sanitary Commission
serves over 10,000 people
PFPeA, PFHxA — Mar 2023 – Jun 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Laurel

Laurel is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Laurel

Water systemService linesTotal
Washington Suburban Sanitary Commission8 lead · 1,277 galvanized · 57,121 unknown58,406

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Laurel drinking water violations

Laurel is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Laurel

Water systemHealth-based violationsMonitoring/reporting
Washington Suburban Sanitary CommissionNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Laurel

SiteTypeDistanceMedianSamplesYears
PG Be 38
USGS Maryland Water Science Center
Well 3.9 mi7 mg/L12003
HO De 51
USGS Maryland Water Science Center
Well 3.9 mi71 mg/L12019
HO Df 60
USGS Maryland Water Science Center
Well 4.8 mi16 mg/L12009
AA Bb 90
USGS Maryland Water Science Center
Well 4.9 mi5 mg/L22009–2016
AA Bb 91
USGS Maryland Water Science Center
Well 4.9 mi50 mg/L22009–2016
AA Bb 92
USGS Maryland Water Science Center
Well 5.2 mi39 mg/L12009

Water hardness in towns near Laurel

TownDistanceMedianClass
South Laurel2 mi 16 mg/LSoft
Maryland City3 mi 16 mg/LSoft
Beltsville5 mi 54 mg/LSoft
Fairland5 mi 60 mg/LModerately hard
Calverton5 mi 90 mg/LModerately hard
Greenbelt7 mi 60 mg/LModerately hard
Cloverly7 mi 92 mg/LModerately hard
Columbia7 mi 50 mg/LSoft
White Oak8 mi 164 mg/LHard
Colesville8 mi 106 mg/LModerately hard

Prince George's County

Laurel is in Prince George's County, where the median is 60 mg/L (moderately hard) across 27 sites.

See all of Prince George's County →

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next