Water hardness in Shelbyville, KY
Water in Shelbyville is very hard, with a median of 198 mg/L (11.5 grains per gallon) across Shelby County.
There are not enough monitoring sites within 10 miles of Shelbyville, so this page uses the Shelby County median.
Shelbyville tap water at a glance
- HardnessVery hard (198 mg/L, 11.5 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
- Lead pipesNo known lead lines; 1 lines are still of unknown material.Check your own pipe →
- Violations1 health-based violation since 2016.What they were →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 198 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 11.5 gpg (11.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Shelbyville
Prefilled with Shelbyville's measured local hardness of 198 mg/L (11.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Shelbyville tap water
Shelbyville Water & Sewer Commission is the main public water system for Shelbyville. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Jan 2025 – Nov 2025. 1 PFAS was detected.
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFPeA perfluoropentanoic acid | 4.3 ppt | 1 of 8 samples | — |
Other water systems serving parts of Shelbyville
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| North Shelby Water District serves over 10,000 people | PFOA | 4.1 / ND ppt | Jun 2025 – Mar 2026 |
| Taylorsville Water Works serves over 10,000 people | PFOA, PFPeA | 6.5 / ND ppt | May 2025 – Feb 2026 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Shelbyville
Shelbyville Water & Sewer Commission reported 9,612 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 157 are galvanized lines that must be replaced, and 1 are still of unknown material.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Shelbyville Water & Sewer Commission whether your address is on its list.
Other water systems serving parts of Shelbyville
| Water system | Service lines | Total |
|---|---|---|
| North Shelby Water District | 0 lead · 13 galvanized · 1,295 unknown | 5,372 |
| Taylorsville Water Works | 55 lead · 85 galvanized · 684 unknown | 9,192 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Shelbyville drinking water violations
EPA records show 1 health-based violation for Shelbyville Water & Sewer Commission since 2016, all since resolved or closed. The most recent began in Jan 2016. It also had 7 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
| Contaminant or rule | Type | Violations | Most recent | Status |
|---|---|---|---|---|
| Haloacetic acids (HAA5) byproducts of chlorine disinfection · what it means highest measured 0.064 MG/L; limit 0.060 mg/L | Contaminant above legal limit | 1 | Jan 2016 | Resolved/closed |
Other water systems serving parts of Shelbyville
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| North Shelby Water District | None | 0 |
| Taylorsville Water Works | None | 1 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Shelbyville
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| CLEAR CREEK NEAR SHELBYVILLE Kentucky Division of Water | River/Stream | 3.6 mi | 185 mg/L | 3 | 2000 |
| BULLSKIN CREEK NEAR SHELBYVILLE Kentucky Division of Water | River/Stream | 4 mi | 210 mg/L | 3 | 2000 |
Water hardness in towns near Shelbyville
| Town | Distance | Median | Class |
|---|---|---|---|
| La Grange | 15 mi | 216 mg/L | Very hard |
| Jeffersontown | 18 mi | 408 mg/L | Very hard |
| Lyndon | 20 mi | 256 mg/L | Very hard |
| Frankfort | 20 mi | 175 mg/L | Hard |
| Mount Washington | 21 mi | 231 mg/L | Very hard |
| Lawrenceburg | 21 mi | 178 mg/L | Hard |
| St. Matthews | 22 mi | 441 mg/L | Very hard |
| Louisville/Jefferson County metro government | 23 mi | 135 mg/L | Hard |
| Bardstown | 30 mi | 203 mg/L | Very hard |
| Shepherdsville | 30 mi | 221 mg/L | Very hard |
Shelby County
Shelbyville is in Shelby County, where the median is 198 mg/L (very hard) across 2 sites.
See all of Shelby County →Shelbyville, KY water: common questions
Do I need a water softener in Shelbyville?
Very likely. Water measured around Shelbyville is 11.5 gpg (198 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 20,000 grains.Size it for your household →
Who supplies Shelbyville's drinking water?
The main public water system serving Shelbyville in EPA records is Shelbyville Water & Sewer Commission. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Shelbyville?
It depends on what you want to remove. In Shelbyville, EPA testing found PFPeA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system had 1 health-based violation since 2016, for Total Haloacetic Acids (HAA5); the utility's annual report says what was done about it. On the other hand, no lead service lines reported. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Which water filters remove PFAS?EPA tests found 1 PFAS in Shelbyville's main water system.
- How to tell if your home has a lead pipe1 service lines here are of unknown material.
- TTHM in drinking waterDisinfection byproducts appear in this system's violation record.