Water hardness in Urbandale, IA

Water in Urbandale is very hard, with a median of 302 mg/L (17.6 grains per gallon) across 8 monitoring sites within 10 miles.

8% softer than the Iowa median (330 mg/L) 21st hardest of 42 Iowa towns Population 46,729
302mg/L
17.6 grains per gallon
Very hard

Urbandale tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 302 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 17.6 gpg (16.9 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites8
Lab samples214
Sample years2000–2005
Middle 50% of sites300–322 mg/L
Groundwater (wells, springs)430 mg/L · 2 sites
Surface water (rivers, lakes)300 mg/L · 6 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Urbandale

Prefilled with Urbandale's measured local hardness of 302 mg/L (17.7 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Urbandale tap water

Urbandale Water Utility is the main public water system for Urbandale. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Aug 2023 – May 2024. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Urbandale

Water systemPFAS detectedHighest PFOA / PFOSTested
Des Moines Water Works
serves over 10,000 people
None detected — Feb 2023 – Nov 2023
Johnston Municipal Water Supply
serves over 10,000 people
None detected — Jan 2025 – Oct 2025
Warren Water District
serves over 10,000 people
None detected — Dec 2023 – Sep 2024
Ia Regional Utilities Assoc (Waverly)
serves over 10,000 people
None detected — Sep 2024 – Mar 2025
Waukee Water Supply
serves over 10,000 people
None detected — Aug 2024 – May 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Urbandale

Urbandale Water Utility reported 17,723 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
17,723not lead (100%)

Other water systems serving parts of Urbandale

Water systemService linesTotal
Des Moines Water Works8,114 lead · 10 galvanized · 45,950 unknown90,731
Johnston Municipal Water Supply0 lead · 0 galvanized · 0 unknown5,506
Warren Water District0 lead · 0 galvanized · 103 unknown8,644
Ia Regional Utilities Assoc (Waverly)0 lead · 0 galvanized · 6,096 unknown16,524
Waukee Water Supply0 lead · 0 galvanized · 110 unknown11,550

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Urbandale drinking water violations

EPA records show no health-based violations for Urbandale Water Utility since 2016.

Other water systems serving parts of Urbandale

Water systemHealth-based violationsMonitoring/reporting
Des Moines Water Works11
Johnston Municipal Water SupplyNone0
Warren Water DistrictNone1
Ia Regional Utilities Assoc (Waverly)None0
Waukee Water SupplyNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Urbandale

SiteTypeDistanceMedianSamplesYears
078N25W10CDDC 19416 1967West Des Moines 1
USGS Iowa Water Science Center
Well 5.4 mi379 mg/L12005
078N25W15CAAC 1954West Des Moines 9
USGS Iowa Water Science Center
Well 6 mi480 mg/L12004
Station #5, Des Moines River at 66th. St.
Des Moines River - Corp of Engineers (IOWA)
River/Stream 6.5 mi302 mg/L442000–2002
Station #5, Des Moines River at 66th. St.
Des Moines River - Corp of Engineers (IOWA)
River/Stream 6.5 mi302 mg/L442000–2002
Saylorville Reservoir - Surface Depth
Des Moines River - Corp of Engineers (IOWA)
Lake 7 mi297 mg/L322001–2002
Saylorville Reservoir - Bottom Depth
Des Moines River - Corp of Engineers (IOWA)
Lake 7 mi300 mg/L302001–2002

Water hardness in towns near Urbandale

TownDistanceMedianClass
Clive2 mi 300 mg/LVery hard
Grimes3 mi 302 mg/LVery hard
Johnston5 mi 300 mg/LVery hard
West Des Moines6 mi 379 mg/LVery hard
Waukee6 mi 379 mg/LVery hard
Des Moines10 mi 301 mg/LVery hard
Ankeny11 mi 299 mg/LVery hard
Norwalk11 mi 300 mg/LVery hard
Pleasant Hill14 mi 286 mg/LVery hard
Altoona16 mi 293 mg/LVery hard

Polk County

Urbandale is in Polk County, where the median is 299 mg/L (very hard) across 22 sites.

See all of Polk County →

Iowa

The statewide median is 330 mg/L (very hard) from 789 sites.

Iowa hardness map →

Urbandale, IA water: common questions

Do I need a water softener in Urbandale?

Very likely. Water measured around Urbandale is 17.6 gpg (302 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 31,000 grains.Size it for your household →

Who supplies Urbandale's drinking water?

The main public water system serving Urbandale in EPA records is Urbandale Water Utility. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Urbandale?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next