Water hardness in Merrillville, IN

Water in Merrillville is very hard, with a median of 316 mg/L (18.4 grains per gallon) across 21 monitoring sites within 10 miles.

about the same as the Indiana median (303 mg/L) 30th hardest of 86 Indiana towns Population 36,347
316mg/L
18.4 grains per gallon
Very hard

Merrillville tap water at a glance

  • HardnessVery hard (316 mg/L, 18.4 gpg, local measurements). Water softeners are common at this level.Size a water softener →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 316 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 18.4 gpg (17.7 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites21
Lab samples230
Sample years2000–2004
Middle 50% of sites165–370 mg/L
Groundwater (wells, springs)130 mg/L · 1 sites
Surface water (rivers, lakes)332 mg/L · 20 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Merrillville

Prefilled with Merrillville's measured local hardness of 316 mg/L (18.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Merrillville tap water

Merrillville is served by more than one water system. These systems supply ZIP codes in Merrillville and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Merrillville

Water systemPFAS detectedHighest PFOA / PFOSTested
Indiana American Water - Northwest
serves over 10,000 people
None detected — Jun 2023 – Mar 2024
Crown Point Water Works
serves over 10,000 people
None detected — Mar 2023 – Mar 2024
ST. John Municipal Water Utility
serves over 10,000 people
None detected — Mar 2025 – Oct 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Merrillville

Merrillville is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Merrillville

Water systemService linesTotal
Indiana American Water - Northwest10,833 lead · 183 galvanized · 36,484 unknown91,302
Crown Point Water Works15 lead · 184 galvanized · 2,563 unknown14,347
ST. John Municipal Water Utility0 lead · 0 galvanized · 0 unknown10,060

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Merrillville drinking water violations

Merrillville is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Merrillville

Water systemHealth-based violationsMonitoring/reporting
Indiana American Water - NorthwestNone0
Crown Point Water WorksNone7
ST. John Municipal Water UtilityNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Merrillville

SiteTypeDistanceMedianSamplesYears
LMG030-0002
Indiana STORET
River/Stream 4.6 mi110 mg/L12000
UMC030-0017
Indiana STORET
River/Stream 5.2 mi361 mg/L12004
LMG030-0008
Indiana STORET
River/Stream 5.3 mi287 mg/L72002–2004
UMC030-0016
Indiana STORET
River/Stream 7 mi370 mg/L32004
UMK130-0011
Indiana STORET
River/Stream 7.6 mi440 mg/L12000
UMK130-0013
Indiana STORET
River/Stream 7.9 mi430 mg/L12000

Water hardness in towns near Merrillville

TownDistanceMedianClass
Hobart4 mi 248 mg/LVery hard
Crown Point5 mi 366 mg/LVery hard
Schererville7 mi 260 mg/LVery hard
Griffith7 mi 282 mg/LVery hard
Lake Station8 mi 247 mg/LVery hard
St. John8 mi 360 mg/LVery hard
Gary8 mi 236 mg/LVery hard
Highland9 mi 260 mg/LVery hard
Cedar Lake9 mi 305 mg/LVery hard
Dyer10 mi 360 mg/LVery hard

Lake County

Merrillville is in Lake County, where the median is 250 mg/L (very hard) across 91 sites.

See all of Lake County →

Indiana

The statewide median is 303 mg/L (very hard) from 1,344 sites.

Indiana hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next