Water hardness in Lake in the Hills, IL
Water in Lake in the Hills is very hard, with a median of 386 mg/L (22.5 grains per gallon) across 42 monitoring sites within 10 miles.
Lake in the Hills tap water at a glance
- HardnessVery hard (386 mg/L, 22.5 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo lead service lines reported.Details →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 386 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 22.5 gpg (21.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Lake in the Hills
Prefilled with Lake in the Hills's measured local hardness of 386 mg/L (22.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Lake in the Hills tap water
The City of Lake in the Hills water system is the main public water system for Lake in the Hills. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 16 samples taken Oct 2024 – Apr 2025. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Lake in the Hills
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Algonquin serves over 10,000 people | None detected | — | May 2024 – Nov 2024 |
| CARY serves over 10,000 people | PFPeA, PFBA, PFHxA +2 more | — | May 2024 – Nov 2024 |
| Crystal Lake serves over 10,000 people | PFBS, PFPeA | — | Dec 2024 – Nov 2025 |
| Huntley serves over 10,000 people | None detected | — | Apr 2024 – Oct 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Lake in the Hills
The City of Lake in the Hills water system reported 9,448 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
Other water systems serving parts of Lake in the Hills
| Water system | Service lines | Total |
|---|---|---|
| Algonquin | 0 lead · 0 galvanized · 3 unknown | 11,718 |
| CARY | 51 lead · 17 galvanized · 0 unknown | 6,439 |
| Crystal Lake | 517 lead · 43 galvanized · 1,109 unknown | 13,787 |
| Huntley | 8 lead · 6 galvanized · 1 unknown | 11,729 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Lake in the Hills drinking water violations
EPA records show no health-based violations for the City of Lake in the Hills water system since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Lake in the Hills
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Algonquin | None | 0 |
| CARY | None | 2 |
| Crystal Lake | None | 12 |
| Huntley | 1 | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Lake in the Hills
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| 43N8E-28.6g USGS Illinois Water Science Center | Well | 0.2 mi | 228 mg/L | 2 | 2000–2021 |
| 43N8E-20.6h1 (17-ALG-S) USGS Illinois Water Science Center | Well | 1.4 mi | 410 mg/L | 2 | 2010–2020 |
| 43N8E-20.6h2 (17-ALG-D) USGS Illinois Water Science Center | Well | 1.4 mi | 241 mg/L | 2 | 2010–2020 |
| Fox River illinois epa (State) | River/Stream | 1.6 mi | 308 mg/L | 24 | 2000–2002 |
| 43N 8E- 9.8c USGS Illinois Water Science Center | Well | 2.5 mi | 404 mg/L | 1 | 2015 |
| 43N8E-8.2c USGS Illinois Water Science Center | Well | 2.6 mi | 418 mg/L | 4 | 2000–2021 |
Water hardness in towns near Lake in the Hills
| Town | Distance | Median | Class |
|---|---|---|---|
| Algonquin | 1 mi | 394 mg/L | Very hard |
| Crystal Lake | 4 mi | 401 mg/L | Very hard |
| Cary | 4 mi | 397 mg/L | Very hard |
| Carpentersville | 4 mi | 401 mg/L | Very hard |
| Huntley | 6 mi | 389 mg/L | Very hard |
| Pingree Grove | 9 mi | 398 mg/L | Very hard |
| Elgin | 10 mi | 360 mg/L | Very hard |
| Barrington | 10 mi | 302 mg/L | Very hard |
| Woodstock | 11 mi | 393 mg/L | Very hard |
| McHenry | 11 mi | 396 mg/L | Very hard |
McHenry County
Lake in the Hills is in McHenry County, where the median is 393 mg/L (very hard) across 98 sites.
See all of McHenry County →Lake in the Hills, IL water: common questions
Do I need a water softener in Lake in the Hills?
Very likely. Water measured around Lake in the Hills is 22.5 gpg (386 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 39,000 grains.Size it for your household →
Who supplies Lake in the Hills's drinking water?
The main public water system serving Lake in the Hills in EPA records is Lake IN the Hills. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Lake in the Hills?
Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.