Water hardness in Elmhurst, IL
Water in Elmhurst is very hard, with a median of 282 mg/L (16.4 grains per gallon) across 12 monitoring sites within 10 miles.
Elmhurst tap water at a glance
- HardnessVery hard (282 mg/L, 16.4 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
- Lead pipesThe water system reported 1,224 lead service lines.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 282 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 16.4 gpg (15.8 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Elmhurst
Prefilled with Elmhurst's measured local hardness of 282 mg/L (16.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Elmhurst tap water
The City of Elmhurst water system is the main public water system for Elmhurst. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jun 2023 – Mar 2024. 1 PFAS was detected.
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFBA perfluorobutanoic acid | 6.3 ppt | 1 of 4 samples | — |
Other water systems serving parts of Elmhurst
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Oak Brook serves over 10,000 people | None detected | — | Nov 2023 – May 2024 |
| Westmont serves over 10,000 people | None detected | — | Dec 2024 – Sep 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Elmhurst
The City of Elmhurst water system reported 15,101 service lines (the pipes connecting homes to the water main) in its inventory. 1,224 are lead and 4 are galvanized lines that must be replaced.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask the City of Elmhurst water system whether your address is on its list.
Other water systems serving parts of Elmhurst
| Water system | Service lines | Total |
|---|---|---|
| Oak Brook | 0 lead · 0 galvanized · 0 unknown | 3,060 |
| Westmont | 122 lead · 113 galvanized · 534 unknown | 6,936 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Elmhurst drinking water violations
EPA records show no health-based violations for the City of Elmhurst water system since 2016.
Other water systems serving parts of Elmhurst
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Oak Brook | None | 3 |
| Westmont | None | 1 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Elmhurst
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| Addison Creek illinois epa (State) | River/Stream | 4 mi | 306 mg/L | 24 | 2000–2002 |
| ADDISON CREEK AT BELLWOOD, IL USGS Illinois Water Science Center | Stream | 4 mi | 237 mg/L | 1 | 2000 |
| SALT CREEK AT WESTERN SPRINGS, IL USGS Illinois Water Science Center | Stream | 5.4 mi | 277 mg/L | 27 | 2000–2001 |
| Salt Creek illinois epa (State) | River/Stream | 5.4 mi | 289 mg/L | 25 | 2000–2002 |
| ADDISON CREEK AT 19TH AVENUE AT BROADVIEW, IL USGS Illinois Water Science Center | Stream | 5.6 mi | 298 mg/L | 1 | 2004 |
| Des Plaines River illinois epa (State) | River/Stream | 6 mi | 286 mg/L | 24 | 2000–2002 |
Water hardness in towns near Elmhurst
| Town | Distance | Median | Class |
|---|---|---|---|
| Villa Park | 2 mi | 282 mg/L | Very hard |
| Northlake | 2 mi | 279 mg/L | Very hard |
| Bellwood | 4 mi | 279 mg/L | Very hard |
| Lombard | 4 mi | 286 mg/L | Very hard |
| Addison | 4 mi | 286 mg/L | Very hard |
| Melrose Park | 4 mi | 277 mg/L | Very hard |
| Bensenville | 4 mi | 283 mg/L | Very hard |
| Franklin Park | 4 mi | 276 mg/L | Very hard |
| Westchester | 4 mi | 277 mg/L | Very hard |
| Wood Dale | 5 mi | 278 mg/L | Very hard |
DuPage County
Elmhurst is in DuPage County, where the median is 287 mg/L (very hard) across 5 sites.
See all of DuPage County →Elmhurst, IL water: common questions
Do I need a water softener in Elmhurst?
Very likely. Water measured around Elmhurst is 16.4 gpg (282 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 29,000 grains.Size it for your household →
Who supplies Elmhurst's drinking water?
The main public water system serving Elmhurst in EPA records is Elmhurst. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Elmhurst?
It depends on what you want to remove. In Elmhurst, EPA testing found PFBA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system reports 1,224 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Which water filters remove PFAS?EPA tests found 1 PFAS in Elmhurst's main water system.
- How to tell if your home has a lead pipe1,224 lead service lines are reported here.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.