Water hardness in Rowland Heights, CA

Water in Rowland Heights is very hard, with a median of 430 mg/L (25.1 grains per gallon) across 27 monitoring sites within 10 miles.

172% harder than the California median (158 mg/L) 33rd hardest of 484 California towns Population 48,993 (2010)
430mg/L
25.1 grains per gallon
Very hard

Rowland Heights tap water at a glance

  • HardnessVery hard (430 mg/L, 25.1 gpg, local measurements). Water softeners are common at this level.Size a water softener →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 430 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 25.1 gpg (24.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites27
Lab samples60
Sample years2000–2020
Middle 50% of sites326–598 mg/L
Groundwater (wells, springs)465 mg/L · 26 sites
Surface water (rivers, lakes)242 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Rowland Heights

Prefilled with Rowland Heights's measured local hardness of 430 mg/L (25.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Rowland Heights tap water

Rowland Heights is served by more than one water system. These systems supply ZIP codes in Rowland Heights and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Rowland Heights

Water systemPFAS detectedHighest PFOA / PFOSTested
Suburban Water Systems-San Jose
serves over 10,000 people
PFBA, PFBS, PFPeA +1 more — Jul 2024 – Apr 2025
Rowland Water District
serves over 10,000 people
PFBA — Feb 2023 – Nov 2023
Walnut Valley Water District
serves over 10,000 people
None detected — Mar 2024 – Nov 2024
San Gabriel Valley Water Co.-EL Monte
serves over 10,000 people
PFBA, PFPeA — Feb 2025 – Aug 2025
GSWC-San Dimas
serves over 10,000 people
PFBA, PFOS ND / 4.6 ppt Nov 2024 – Aug 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Rowland Heights

Rowland Heights is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Rowland Heights

Water systemService linesTotal
Suburban Water Systems-San Jose0 lead · 0 galvanized · 0 unknown40,826
Rowland Water District0 lead · 0 galvanized · 0 unknown13,750
Walnut Valley Water District0 lead · 0 galvanized · 0 unknown27,655
San Gabriel Valley Water Co.-EL Monte0 lead · 0 galvanized · 0 unknown48,369
GSWC-San Dimas0 lead · 0 galvanized · 0 unknown16,303

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Rowland Heights drinking water violations

Rowland Heights is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Rowland Heights

Water systemHealth-based violationsMonitoring/reporting
Suburban Water Systems-San JoseNone1
Rowland Water DistrictNone0
Walnut Valley Water DistrictNone0
San Gabriel Valley Water Co.-EL Monte20
GSWC-San DimasNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Rowland Heights

SiteTypeDistanceMedianSamplesYears
003S011W02K007S
USGS California Water Science Center
Well 6.7 mi365 mg/L12000
003S011W02K006S
USGS California Water Science Center
Well 6.7 mi340 mg/L12000
003S011W02K005S
USGS California Water Science Center
Well 6.7 mi1010 mg/L12000
003S011W02K004S
USGS California Water Science Center
Well 6.7 mi1030 mg/L12000
003S011W02K008S
USGS California Water Science Center
Well 6.7 mi672 mg/L12000
001S010W24M004S
USGS California Water Science Center
Well 6.8 mi510 mg/L42008–2020

Water hardness in towns near Rowland Heights

TownDistanceMedianClass
South San Jose Hills3 mi 283 mg/LVery hard
Brea3 mi 334 mg/LVery hard
La Habra5 mi 284 mg/LVery hard
Diamond Bar5 mi 234 mg/LVery hard
Walnut5 mi 202 mg/LVery hard
Hacienda Heights5 mi 238 mg/LVery hard
Valinda5 mi 254 mg/LVery hard
La Puente6 mi 268 mg/LVery hard
West Covina6 mi 242 mg/LVery hard
Fullerton6 mi 323 mg/LVery hard

Los Angeles County

Rowland Heights is in Los Angeles County, where the median is 200 mg/L (very hard) across 552 sites.

See all of Los Angeles County →

California

The statewide median is 158 mg/L (hard) from 5,772 sites.

California hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next