Water hardness in San Tan Valley, AZ

Water in San Tan Valley is very hard, with a median of 195 mg/L (11.4 grains per gallon) across Pinal County.

about the same as the Arizona median (205 mg/L) 38th hardest of 65 Arizona towns Population 81,321 (2010)
195mg/L
11.4 grains per gallon
Very hard

There are not enough monitoring sites within 10 miles of San Tan Valley, so this page uses the Pinal County median.

San Tan Valley tap water at a glance

  • HardnessVery hard (195 mg/L, 11.4 gpg, local measurements). Water softeners are common at this level.Size a water softener →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 195 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 11.4 gpg (10.9 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites321
Lab samples1,270
Sample years2000–2025
Middle 50% of sites100–320 mg/L
Groundwater (wells, springs)218 mg/L · 168 sites
Surface water (rivers, lakes)160 mg/L · 153 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for San Tan Valley

Prefilled with San Tan Valley's measured local hardness of 195 mg/L (11.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in San Tan Valley tap water

San Tan Valley is served by more than one water system. These systems supply ZIP codes in San Tan Valley and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving San Tan Valley

Water systemPFAS detectedHighest PFOA / PFOSTested
Epcor - San Tan
serves over 10,000 people
None detected — Jul 2024 – Jan 2025
Town of Queen Creek
serves over 10,000 people
None detected — Feb 2024 – Dec 2025
Town of Gilbert
serves over 10,000 people
PFBS, PFOS, PFOA +3 more 6.5 / 9.8 ppt Nov 2023 – Nov 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in San Tan Valley

San Tan Valley is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving San Tan Valley

Water systemService linesTotal
Epcor - San Tan0 lead · 0 galvanized · 0 unknown41,895
Town of Queen Creek0 lead · 0 galvanized · 52 unknown49,363
Town of Gilbert0 lead · 0 galvanized · 9,578 unknown86,557

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

San Tan Valley drinking water violations

San Tan Valley is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving San Tan Valley

Water systemHealth-based violationsMonitoring/reporting
Epcor - San Tan253
Town of Queen CreekNone10
Town of Gilbert3222

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to San Tan Valley

SiteTypeDistanceMedianSamplesYears
D-04-09 06AAA2
USGS Arizona Water Science Center
Well 7.5 mi619 mg/L32000–2008
D-02-07 07DAA
USGS Arizona Water Science Center
Well 8.9 mi185 mg/L12013

Water hardness in towns near San Tan Valley

TownDistanceMedianClass
Queen Creek5 mi 195 mg/LVery hard
Florence11 mi 360 mg/LVery hard
Gilbert14 mi 186 mg/LVery hard
Apache Junction14 mi 195 mg/LVery hard
Coolidge17 mi 385 mg/LVery hard
Mesa18 mi 186 mg/LVery hard
Sun Lakes18 mi 203 mg/LVery hard
Chandler18 mi 194 mg/LVery hard
Casa Grande22 mi 154 mg/LHard
Tempe26 mi 202 mg/LVery hard

Pinal County

San Tan Valley is in Pinal County, where the median is 195 mg/L (very hard) across 321 sites.

See all of Pinal County →

Arizona

The statewide median is 205 mg/L (very hard) from 3,750 sites.

Arizona hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next