Water hardness in Russellville, AL

Water in Russellville is moderately hard, with a median of 116 mg/L (6.8 grains per gallon) across 15 monitoring sites within 10 miles.

158% harder than the Alabama median (45 mg/L) 23rd hardest of 69 Alabama towns Population 10,722
116mg/L
6.8 grains per gallon
Moderately hard

Russellville tap water at a glance

  • HardnessModerately hard (116 mg/L, 6.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 116 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 6.8 gpg (6.5 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites15
Lab samples64
Sample years2002–2026
Middle 50% of sites97–124 mg/L
Surface water (rivers, lakes)116 mg/L · 15 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Russellville

Prefilled with Russellville's measured local hardness of 116 mg/L (6.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Russellville tap water

Russellville Water Works is the main public water system for Russellville. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 6 samples taken Aug 2023 – Jun 2024. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Russellville

Water systemPFAS detectedHighest PFOA / PFOSTested
Colbert County Rural Water System
serves over 10,000 people
PFBA, PFOS, PFOA +5 more 19.8 / 29.5 ppt Jul 2023 – May 2024
West Lawrence Water Coop
serves over 10,000 people
PFBA, PFBS — Nov 2024 – Aug 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Russellville

Russellville Water Works reported 6,500 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 294 are galvanized lines that must be replaced.

0lead (0%)
294galvanized requiring replacement
0unknown material (0%)
6,206not lead (95%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Russellville Water Works whether your address is on its list.

Other water systems serving parts of Russellville

Water systemService linesTotal
Colbert County Rural Water System0 lead · 0 galvanized · 0 unknown5,552
West Lawrence Water Coop16 lead · 0 galvanized · 0 unknown1,585

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Russellville drinking water violations

EPA records show no health-based violations for Russellville Water Works since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Russellville

Water systemHealth-based violationsMonitoring/reporting
Colbert County Rural Water SystemNone42
West Lawrence Water CoopNone3

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Russellville

SiteTypeDistanceMedianSamplesYears
MUDF-3
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 2.8 mi196 mg/L22026
CDRF-5
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 3.2 mi126 mg/L42013
CDRF-1
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 4.5 mi114 mg/L32003–2026
ELLF-1
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
Reservoir 4.6 mi118 mg/L42023
HAMF-1
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 5 mi116 mg/L22003
CEDF-1
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 5.8 mi131 mg/L42013

Water hardness in towns near Russellville

TownDistanceMedianClass
Muscle Shoals17 mi 90 mg/LModerately hard
Florence23 mi 73 mg/LModerately hard
Decatur42 mi 70 mg/LModerately hard
Hartselle45 mi 134 mg/LHard
Athens48 mi 56 mg/LSoft
Jasper52 mi 131 mg/LHard
Cullman55 mi 40 mg/LSoft
Madison57 mi 97 mg/LModerately hard
Huntsville61 mi 118 mg/LModerately hard
Gardendale78 mi 173 mg/LHard

Franklin County

Russellville is in Franklin County, where the median is 64 mg/L (moderately hard) across 27 sites.

See all of Franklin County →

Alabama

The statewide median is 45 mg/L (soft) from 2,227 sites.

Alabama hardness map →

Russellville, AL water: common questions

Do I need a water softener in Russellville?

Probably not. Water measured around Russellville is 6.8 gpg (116 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 12,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Russellville's drinking water?

The main public water system serving Russellville in EPA records is Russellville Water Works. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Russellville?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next