Water hardness in Port Washington, WI
Water in Port Washington is very hard, with a median of 318 mg/L (18.6 grains per gallon) across Ozaukee County.
There are not enough monitoring sites within 10 miles of Port Washington, so this page uses the Ozaukee County median.
Port Washington tap water at a glance
- HardnessVery hard (318 mg/L, 18.6 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesThe water system reported 249 lead service lines.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 318 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 18.6 gpg (17.8 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Port Washington
Prefilled with Port Washington's measured local hardness of 318 mg/L (18.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Port Washington tap water
Port Washington Waterworks is the main public water system for Port Washington. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jan 2023 – Oct 2023. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Port Washington
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Grafton Waterworks serves over 10,000 people | None detected | — | Oct 2023 – Sep 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Port Washington
Port Washington Waterworks reported 4,087 service lines (the pipes connecting homes to the water main) in its inventory. 249 are lead and 102 are galvanized lines that must be replaced, and 897 are still of unknown material.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Port Washington Waterworks whether your address is on its list.
Other water systems serving parts of Port Washington
| Water system | Service lines | Total |
|---|---|---|
| Grafton Waterworks | 0 lead · 0 galvanized · 0 unknown | 4,444 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Port Washington drinking water violations
EPA records show no health-based violations for Port Washington Waterworks since 2016. It also had 4 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Port Washington
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Grafton Waterworks | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Port Washington
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| MILWAUKEE RIVER NEAR CEDARBURG, WI USGS Wisconsin Water Science Center | Stream | 7.8 mi | 318 mg/L | 12 | 2004–2005 |
| CEDAR CREEK AT GREEN BAY ROAD AT CEDARBURG, WI USGS Wisconsin Water Science Center | Stream | 8.3 mi | 300 mg/L | 1 | 2018 |
Water hardness in towns near Port Washington
| Town | Distance | Median | Class |
|---|---|---|---|
| Grafton | 5 mi | 300 mg/L | Very hard |
| Cedarburg | 8 mi | 295 mg/L | Very hard |
| Mequon | 14 mi | 298 mg/L | Very hard |
| West Bend | 15 mi | 304 mg/L | Very hard |
| Brown Deer | 15 mi | 300 mg/L | Very hard |
| Germantown | 16 mi | 346 mg/L | Very hard |
| Glendale | 18 mi | 244 mg/L | Very hard |
| Whitefish Bay | 19 mi | 242 mg/L | Very hard |
| Menomonee Falls | 20 mi | 335 mg/L | Very hard |
| Richfield | 20 mi | 266 mg/L | Very hard |
Ozaukee County
Port Washington is in Ozaukee County, where the median is 318 mg/L (very hard) across 3 sites.
See all of Ozaukee County →Port Washington, WI water: common questions
Do I need a water softener in Port Washington?
Very likely. Water measured around Port Washington is 18.6 gpg (318 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 33,000 grains.Size it for your household →
Who supplies Port Washington's drinking water?
The main public water system serving Port Washington in EPA records is Port Washington Waterworks. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Port Washington?
It depends on what you want to remove. In Port Washington, the system reports 249 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no PFAS found in EPA testing and no health-based violations since 2016. A water softener is not a filter.Check your own service line →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- How to tell if your home has a lead pipe249 lead service lines are reported here.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.