Water hardness in Tacoma, WA

Water in Tacoma is moderately hard, with a median of 63 mg/L (3.7 grains per gallon) across 19 monitoring sites within 10 miles.

15% softer than the Washington median (74 mg/L) 64th hardest of 122 Washington towns Population 222,906
63mg/L
3.7 grains per gallon
Moderately hard

Large city utilities sometimes soften, blend or import water from distant reservoirs, so tap water in Tacoma can differ from local source water. Your utility's annual Consumer Confidence Report lists the exact tap value.

Tacoma tap water at a glance

  • HardnessModerately hard (63 mg/L, 3.7 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFAS2 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 63 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 3.7 gpg (3.5 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites19
Lab samples71
Sample years2000–2016
Middle 50% of sites41–80 mg/L
Groundwater (wells, springs)57 mg/L · 12 sites
Surface water (rivers, lakes)64 mg/L · 7 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Tacoma

Prefilled with Tacoma's measured local hardness of 63 mg/L (3.7 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Tacoma tap water

City of Tacoma Water Division is the main public water system for Tacoma. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Jan 2025 – Oct 2025. 2 PFAS were detected. Every result with a federal limit was at or below it.

ChemicalHighest resultDetected inEPA limit
PFHxS
perfluorohexane sulfonic acid
5.1 ppt 4 of 8 samples 10 ppt*
PFBS
perfluorobutane sulfonic acid
3.3 ppt 1 of 8 samples —

Other water systems serving parts of Tacoma

Water systemPFAS detectedHighest PFOA / PFOSTested
Parkland Light & Water Company
serves over 10,000 people
PFOS, PFBS, PFOA +3 more 6.2 / 13.8 ppt Feb 2024 – Aug 2024
Summit Water & Supply
serves over 10,000 people
PFPeA — May 2023 – Nov 2023
Fife Dept of Public Works
serves over 10,000 people
PFHxS, PFBS — Jan 2025 – Oct 2025
Lakewood Water District
serves over 10,000 people
PFPeA, PFBA, PFOS +2 more ND / 5.9 ppt Apr 2024 – Oct 2024
Spanaway Water Company
serves over 10,000 people
PFOS, PFBS, PFOA +3 more 6.2 / 8.3 ppt Aug 2024 – Feb 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Tacoma

City of Tacoma Water Division reported 114,107 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
114,107not lead (100%)

Other water systems serving parts of Tacoma

Water systemService linesTotal
Parkland Light & Water Company0 lead · 0 galvanized · 2,644 unknown10,644
Summit Water & Supply0 lead · 0 galvanized · 0 unknown4,960
Fife Dept of Public Works0 lead · 0 galvanized · 0 unknown3,005
Lakewood Water District0 lead · 0 galvanized · 5 unknown17,192
Spanaway Water Company0 lead · 0 galvanized · 0 unknown10,935

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Tacoma drinking water violations

EPA records show no health-based violations for City of Tacoma Water Division since 2016.

Other water systems serving parts of Tacoma

Water systemHealth-based violationsMonitoring/reporting
Parkland Light & Water CompanyNone3
Summit Water & SupplyNone1
Fife Dept of Public WorksNone2
Lakewood Water DistrictNone1
Spanaway Water CompanyNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Tacoma

SiteTypeDistanceMedianSamplesYears
SWAN CREEK AT PIONEER WAY TACOMA, WA
USGS Washington Water Science Center
Stream 3.6 mi83 mg/L102015
20N/03E-30L14
USGS Washington Water Science Center
Well 4.5 mi122 mg/L12016
FLETT CR. @ 75TH ST. W.
Washington Department Of Ecology
River/Stream 5.2 mi63 mg/L62010–2011
HYLEBOS CREEK @ 8TH ST. E
Washington Department Of Ecology
River/Stream 5.2 mi93 mg/L62010–2011
20N/02E-28L01 UR-36
USGS Washington Water Science Center
Well 6.6 mi111 mg/L12005
Clover Cr abv Steilacoom Lk
Washington Department Of Ecology
River/Stream 7.3 mi51 mg/L52011–2012

Water hardness in towns near Tacoma

TownDistanceMedianClass
University Place5 mi 51 mg/LSoft
Fife5 mi 70 mg/LModerately hard
Lakewood7 mi 51 mg/LSoft
Federal Way7 mi 80 mg/LModerately hard
Parkland8 mi 52 mg/LSoft
Edgewood8 mi 76 mg/LModerately hard
Lakeland South8 mi 61 mg/LModerately hard
Gig Harbor9 mi 45 mg/LSoft
Puyallup9 mi 62 mg/LModerately hard
Artondale10 mi 45 mg/LSoft

Pierce County

Tacoma is in Pierce County, where the median is 51 mg/L (soft) across 73 sites.

See all of Pierce County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Tacoma, WA water: common questions

Do I need a water softener in Tacoma?

Probably not. Water measured around Tacoma is 3.7 gpg (63 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 7,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Tacoma's drinking water?

The main public water system serving Tacoma in EPA records is City of Tacoma Water Division. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Tacoma?

It depends on what you want to remove. In Tacoma, EPA testing found PFHxS and PFBS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next