Water hardness in Monroe, WA
Water in Monroe is soft, with a median of 31 mg/L (1.8 grains per gallon) across 5 monitoring sites within 10 miles.
Monroe tap water at a glance
- HardnessSoft (31 mg/L, 1.8 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo known lead lines; 328 lines are still of unknown material.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 31 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.8 gpg (1.7 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Monroe
Prefilled with Monroe's measured local hardness of 31 mg/L (1.8 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Monroe tap water
Monroe Water System is the main public water system for Monroe. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken May 2023 – Mar 2024. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Monroe
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| City of Everett Public Works Dept. serves over 10,000 people | None detected | — | Feb 2023 – Nov 2023 |
| Cross Valley Water District serves over 10,000 people | PFBS, PFHxA, PFPeA | — | May 2024 – Feb 2025 |
| Sno Pud 1 - Lake Stevens serves over 10,000 people | None detected | — | Jan 2024 – Dec 2024 |
| City of Snohomish serves over 10,000 people | None detected | — | Jan 2025 – Oct 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Monroe
Monroe Water System reported 7,555 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 328 lines are still of unknown material.
Other water systems serving parts of Monroe
| Water system | Service lines | Total |
|---|---|---|
| City of Everett Public Works Dept. | 0 lead · 0 galvanized · 0 unknown | 29,738 |
| Cross Valley Water District | 0 lead · 0 galvanized · 0 unknown | 7,179 |
| Sno Pud 1 - Lake Stevens | 0 lead · 0 galvanized · 0 unknown | 21,499 |
| City of Snohomish | 0 lead · 0 galvanized · 0 unknown | 2,310 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Monroe drinking water violations
EPA records show no health-based violations for Monroe Water System since 2016. It also had 3 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Monroe
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| City of Everett Public Works Dept. | None | 2 |
| Cross Valley Water District | None | 3 |
| Sno Pud 1 - Lake Stevens | None | 2 |
| City of Snohomish | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Monroe
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| 28N/07E-28G04 SU-026 USGS Washington Water Science Center | Well | 3.9 mi | 45 mg/L | 1 | 2016 |
| SNOQUALMIE RIVER NEAR MONROE Washington Department Of Ecology | River/Stream | 4 mi | 18 mg/L | 6 | 2011–2012 |
| French Cr nr Mouth Washington Department Of Ecology | River/Stream | 4.6 mi | 66 mg/L | 6 | 2011–2012 |
| CHERRY CREEK BELOW MARGARET CREEK NEAR DUVALL, WA USGS Washington Water Science Center | Stream | 8.3 mi | 28 mg/L | 4 | 2015 |
| DUBUQUE CREEK BLW PANTHER CREEK NR LK STEVENS, WA USGS Washington Water Science Center | Stream | 9.1 mi | 31 mg/L | 10 | 2015 |
Water hardness in towns near Monroe
| Town | Distance | Median | Class |
|---|---|---|---|
| Maltby | 7 mi | 68 mg/L | Moderately hard |
| Snohomish | 7 mi | 38 mg/L | Soft |
| Silver Firs | 8 mi | 70 mg/L | Moderately hard |
| Cottage Lake | 9 mi | 66 mg/L | Moderately hard |
| Eastmont | 10 mi | 70 mg/L | Moderately hard |
| Mill Creek East | 10 mi | 75 mg/L | Moderately hard |
| Woodinville | 10 mi | 70 mg/L | Moderately hard |
| Mill Creek | 11 mi | 82 mg/L | Moderately hard |
| Lake Stevens | 11 mi | 37 mg/L | Soft |
| Martha Lake | 12 mi | 88 mg/L | Moderately hard |
Snohomish County
Monroe is in Snohomish County, where the median is 31 mg/L (soft) across 99 sites.
See all of Snohomish County →Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Monroe, WA water: common questions
Do I need a water softener in Monroe?
Probably not. Water measured around Monroe is 1.8 gpg (31 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Monroe's drinking water?
The main public water system serving Monroe in EPA records is Monroe Water System. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Monroe?
Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →
Hardness scale
What to read next
- How to tell if your home has a lead pipe328 service lines here are of unknown material.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.