Water hardness in Mechanicsville, VA
Water in Mechanicsville is soft, with a median of 27 mg/L (1.6 grains per gallon) across 55 monitoring sites within 10 miles.
Mechanicsville tap water at a glance
- HardnessSoft (27 mg/L, 1.6 gpg, local measurements). A water softener isn't needed.Water heater care →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 27 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.6 gpg (1.5 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Mechanicsville
Prefilled with Mechanicsville's measured local hardness of 27 mg/L (1.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Mechanicsville tap water
Mechanicsville is served by more than one water system. These systems supply ZIP codes in Mechanicsville and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.
Water systems serving Mechanicsville
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Hanover Suburban Water System serves over 10,000 people | None detected | — | Jun 2024 – Mar 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Mechanicsville
Mechanicsville is served by more than one water system. Their service line inventories, as reported to EPA:
Water systems serving Mechanicsville
| Water system | Service lines | Total |
|---|---|---|
| Hanover Suburban Water System | 0 lead · 4 galvanized · 6,781 unknown | 24,251 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Mechanicsville drinking water violations
Mechanicsville is served by more than one water system. Health-based violations recorded by EPA since 2016:
Water systems serving Mechanicsville
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Hanover Suburban Water System | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Mechanicsville
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| BRANDY BRANCH BELOW RT 643 AT SPRING MEADOWS, VA USGS Maryland Water Science Center | Stream | 1.7 mi | 13 mg/L | 1 | 2000 |
| TOTOPOTOMOY CREEK TRIBUTARY NEAR STUDLEY, VA USGS Maryland Water Science Center | Stream | 1.9 mi | 23 mg/L | 1 | 2000 |
| SWANNANOA SOW 236-C WELL VIRGINIA DEPARTMENT OF ENVIRONMENTAL QUALITY | Well | 2.1 mi | 13 mg/L | 1 | 2014 |
| SWANNANOA SOW 236-B WELL VIRGINIA DEPARTMENT OF ENVIRONMENTAL QUALITY | Well | 2.1 mi | 152 mg/L | 1 | 2014 |
| 52K 25 SOW 236C USGS Virginia Water Science Center | Well: Multiple wells | 2.2 mi | 10 mg/L | 1 | 2015 |
| 52K 23 SOW 236A USGS Virginia Water Science Center | Well: Multiple wells | 2.2 mi | 173 mg/L | 1 | 2015 |
Water hardness in towns near Mechanicsville
| Town | Distance | Median | Class |
|---|---|---|---|
| East Highland Park | 4 mi | 28 mg/L | Soft |
| Highland Springs | 6 mi | 23 mg/L | Soft |
| Lakeside | 7 mi | 40 mg/L | Soft |
| Glen Allen | 8 mi | 40 mg/L | Soft |
| Laurel | 8 mi | 40 mg/L | Soft |
| Richmond | 10 mi | 33 mg/L | Soft |
| Tuckahoe | 13 mi | 41 mg/L | Soft |
| Bon Air | 14 mi | 29 mg/L | Soft |
| Manchester | 14 mi | 28 mg/L | Soft |
| Short Pump | 15 mi | 40 mg/L | Soft |
Hanover County
Mechanicsville is in Hanover County, where the median is 20 mg/L (soft) across 39 sites.
See all of Hanover County →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.