Water hardness in Brushy Creek, TX

Water in Brushy Creek is very hard, with a median of 356 mg/L (20.8 grains per gallon) across 20 monitoring sites within 10 miles.

84% harder than the Texas median (194 mg/L) 20th hardest of 251 Texas towns Population 21,764 (2010)
356mg/L
20.8 grains per gallon
Very hard

Brushy Creek tap water at a glance

  • HardnessVery hard (356 mg/L, 20.8 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • PFAS5 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 356 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 20.8 gpg (19.9 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites20
Lab samples84
Sample years2000–2022
Middle 50% of sites312–401 mg/L
Groundwater (wells, springs)356 mg/L · 20 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Brushy Creek

Prefilled with Brushy Creek's measured local hardness of 356 mg/L (20.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Brushy Creek tap water

Brushy Creek MUD is the main public water system for Brushy Creek. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Apr 2023 – Mar 2024. 5 PFAS were detected. Every result with a federal limit was at or below it.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
6.1 ppt 2 of 4 samples —
PFPeA
perfluoropentanoic acid
6 ppt 4 of 4 samples —
PFBS
perfluorobutane sulfonic acid
5.5 ppt 4 of 4 samples —
PFHxA
perfluorohexanoic acid
3.8 ppt 3 of 4 samples —
PFHxS
perfluorohexane sulfonic acid
3.7 ppt 4 of 4 samples 10 ppt*

Other water systems serving parts of Brushy Creek

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Austin Water & Wastewater
serves over 10,000 people
PFBA, PFHxS, PFBS +3 more ND / 4.8 ppt Oct 2023 – Jul 2024
Manville WSC
serves over 10,000 people
PFNA, PFOS, PFBS +7 more 5.9 / 12.4 ppt Feb 2023 – Nov 2023
North Austin MUD 1
serves over 10,000 people
None detected — Aug 2023 – May 2024
City of Georgetown
serves over 10,000 people
PFBA, PFPeA, PFHxA +4 more 4.9 / 5.7 ppt Jun 2023 – Feb 2025
City of Round Rock
serves over 10,000 people
PFPeA, PFBS, PFBA +1 more — Oct 2024 – Jul 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Brushy Creek

Brushy Creek MUD reported 5,880 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
5,880not lead (100%)

Other water systems serving parts of Brushy Creek

Water systemService linesTotal
City of Austin Water & Wastewater0 lead · 777 galvanized · 0 unknown257,784
Manville WSC0 lead · 0 galvanized · 0 unknown12,511
North Austin MUD 10 lead · 0 galvanized · 0 unknown2,657
City of Georgetown0 lead · 161 galvanized · 4 unknown62,099
City of Round Rock0 lead · 0 galvanized · 311 unknown8,458

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Brushy Creek drinking water violations

EPA records show no health-based violations for Brushy Creek MUD since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Brushy Creek

Water systemHealth-based violationsMonitoring/reporting
City of Austin Water & Wastewater50
Manville WSC56
North Austin MUD 1None0
City of Georgetown12
City of Round RockNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Brushy Creek

SiteTypeDistanceMedianSamplesYears
ZK-58-27-721
USGS Texas Water Science Center
Well 1.1 mi363 mg/L12008
ZK-58-35-112
USGS Texas Water Science Center
Well 1.2 mi272 mg/L42007–2011
ZK-58-34-309
USGS Texas Water Science Center
Well 2.6 mi393 mg/L12008
ZK-58-27-838
USGS Texas Water Science Center
Well 2.6 mi425 mg/L32008–2011
ZK-58-27-505
USGS Texas Water Science Center
Well 3.8 mi332 mg/L12009
ZK-58-26-808
USGS Texas Water Science Center
Well 3.9 mi474 mg/L12008

Water hardness in towns near Brushy Creek

TownDistanceMedianClass
Cedar Park5 mi 351 mg/LVery hard
Round Rock5 mi 366 mg/LVery hard
Wells Branch6 mi 370 mg/LVery hard
Leander8 mi 340 mg/LVery hard
Pflugerville9 mi 332 mg/LVery hard
Georgetown11 mi 326 mg/LVery hard
Hutto12 mi 332 mg/LVery hard
Liberty Hill14 mi 322 mg/LVery hard
Austin15 mi 93 mg/LModerately hard
Manor15 mi 323 mg/LVery hard

Williamson County

Brushy Creek is in Williamson County, where the median is 322 mg/L (very hard) across 20 sites.

See all of Williamson County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Brushy Creek, TX water: common questions

Do I need a water softener in Brushy Creek?

Very likely. Water measured around Brushy Creek is 20.8 gpg (356 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 36,000 grains.Size it for your household →

Who supplies Brushy Creek's drinking water?

The main public water system serving Brushy Creek in EPA records is Brushy Creek MUD. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Brushy Creek?

It depends on what you want to remove. In Brushy Creek, EPA testing found PFBA, PFPeA and PFBS and 2 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next