Water hardness in Cedar Park, TX
Water in Cedar Park is very hard, with a median of 351 mg/L (20.5 grains per gallon) across 16 monitoring sites within 10 miles.
Cedar Park tap water at a glance
- HardnessVery hard (351 mg/L, 20.5 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
- Lead pipesNo lead service lines reported.Details →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 351 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 20.5 gpg (19.7 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Cedar Park
Prefilled with Cedar Park's measured local hardness of 351 mg/L (20.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Cedar Park tap water
City of Cedar Park is the main public water system for Cedar Park. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken May 2024 – May 2025. 1 PFAS was detected.
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFBA perfluorobutanoic acid | 5 ppt | 1 of 8 samples | — |
Other water systems serving parts of Cedar Park
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| City of Austin Water & Wastewater serves over 10,000 people | PFBA, PFHxS, PFBS +3 more | ND / 4.8 ppt | Oct 2023 – Jul 2024 |
| Manville WSC serves over 10,000 people | PFNA, PFOS, PFBS +7 more | 5.9 / 12.4 ppt | Feb 2023 – Nov 2023 |
| North Austin MUD 1 serves over 10,000 people | None detected | — | Aug 2023 – May 2024 |
| City of Georgetown serves over 10,000 people | PFBA, PFPeA, PFHxA +4 more | 4.9 / 5.7 ppt | Jun 2023 – Feb 2025 |
| City of Leander serves over 10,000 people | PFBA | — | May 2024 – May 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Cedar Park
City of Cedar Park reported 22,696 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
Other water systems serving parts of Cedar Park
| Water system | Service lines | Total |
|---|---|---|
| City of Austin Water & Wastewater | 0 lead · 777 galvanized · 0 unknown | 257,784 |
| Manville WSC | 0 lead · 0 galvanized · 0 unknown | 12,511 |
| North Austin MUD 1 | 0 lead · 0 galvanized · 0 unknown | 2,657 |
| City of Georgetown | 0 lead · 161 galvanized · 4 unknown | 62,099 |
| City of Leander | 0 lead · 0 galvanized · 6,716 unknown | 26,978 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Cedar Park drinking water violations
EPA records show no health-based violations for City of Cedar Park since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Cedar Park
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| City of Austin Water & Wastewater | 5 | 0 |
| Manville WSC | 5 | 6 |
| North Austin MUD 1 | None | 0 |
| City of Georgetown | 1 | 2 |
| City of Leander | None | 10 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Cedar Park
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| ZK-58-26-808 USGS Texas Water Science Center | Well | 0.9 mi | 474 mg/L | 1 | 2008 |
| ZK-58-34-210 USGS Texas Water Science Center | Well | 1.4 mi | 317 mg/L | 1 | 2008 |
| ZK-58-34-309 USGS Texas Water Science Center | Well | 3 mi | 393 mg/L | 1 | 2008 |
| ZK-58-34-621 USGS Texas Water Science Center | Well | 5 mi | 371 mg/L | 1 | 2008 |
| ZK-58-35-112 USGS Texas Water Science Center | Well | 5.1 mi | 272 mg/L | 4 | 2007–2011 |
| ZK-58-27-721 USGS Texas Water Science Center | Well | 5.8 mi | 363 mg/L | 1 | 2008 |
Water hardness in towns near Cedar Park
| Town | Distance | Median | Class |
|---|---|---|---|
| Brushy Creek | 5 mi | 356 mg/L | Very hard |
| Leander | 5 mi | 340 mg/L | Very hard |
| Wells Branch | 9 mi | 370 mg/L | Very hard |
| Round Rock | 10 mi | 366 mg/L | Very hard |
| Lago Vista | 11 mi | 254 mg/L | Very hard |
| Liberty Hill | 12 mi | 322 mg/L | Very hard |
| Georgetown | 13 mi | 326 mg/L | Very hard |
| Pflugerville | 14 mi | 332 mg/L | Very hard |
| Lakeway | 15 mi | 206 mg/L | Very hard |
| Austin | 15 mi | 93 mg/L | Moderately hard |
Williamson County
Cedar Park is in Williamson County, where the median is 322 mg/L (very hard) across 20 sites.
See all of Williamson County →Cedar Park, TX water: common questions
Do I need a water softener in Cedar Park?
Very likely. Water measured around Cedar Park is 20.5 gpg (351 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 36,000 grains.Size it for your household →
Who supplies Cedar Park's drinking water?
The main public water system serving Cedar Park in EPA records is City of Cedar Park. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Cedar Park?
It depends on what you want to remove. In Cedar Park, EPA testing found PFBA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Which water filters remove PFAS?EPA tests found 1 PFAS in Cedar Park's main water system.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.