Water hardness in Statesville, NC
Water in Statesville is soft, with a median of 26 mg/L (1.5 grains per gallon) across 15 monitoring sites within 10 miles.
Statesville tap water at a glance
- HardnessSoft (26 mg/L, 1.5 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo known lead lines; 12,278 lines are still of unknown material.Check your own pipe →
- Violations2 health-based violations since 2016.What they were →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 26 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.5 gpg (1.5 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Statesville
Prefilled with Statesville's measured local hardness of 26 mg/L (1.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Statesville tap water
City of Statesville is the main public water system for Statesville. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Apr 2024 – Jan 2025. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Statesville
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Iredell Water Corporation serves over 10,000 people | PFPeA, PFHxA, PFOA +5 more | 18.8 / 4.9 ppt | Apr 2024 – Mar 2025 |
| Energy United Water Corp serves over 10,000 people | None detected | — | Mar 2025 – Dec 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Statesville
City of Statesville reported 14,723 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 1 are galvanized lines that must be replaced, and 12,278 are still of unknown material.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Statesville whether your address is on its list.
Other water systems serving parts of Statesville
| Water system | Service lines | Total |
|---|---|---|
| Iredell Water Corporation | 0 lead · 0 galvanized · 613 unknown | 11,709 |
| Energy United Water Corp | 0 lead · 0 galvanized · 0 unknown | 5,741 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Statesville drinking water violations
EPA records show 2 health-based violations for City of Statesville since 2016, all since resolved or closed. The most recent began in Oct 2024. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
| Contaminant or rule | Type | Violations | Most recent | Status |
|---|---|---|---|---|
| Lead and Copper Rule Revisions lead service line inventory and lead rule requirements | Treatment requirement not met | 1 | Oct 2024 | Resolved/closed |
| Surface water treatment (filtration/turbidity) filtration requirements that protect against microbes such as Cryptosporidium | Treatment requirement not met | 1 | Apr 2017 | Resolved/closed |
Other water systems serving parts of Statesville
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Iredell Water Corporation | 1 | 5 |
| Energy United Water Corp | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Statesville
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| IR-190 NR STATESVILLE, NC MAFIC GNEISS USGS North Carolina Water Science Center | Well | 6.8 mi | 56 mg/L | 1 | 2014 |
| FOURTH CRK AT SR 2308 NR ELMWOOD NCDENR-DWQ (2nd) | River/Stream | 7 mi | 42 mg/L | 12 | 2000–2001 |
| FOURTH CRK AT SR 2308 NR ELMWOOD North Carolina Dept of Environmental Quality NCDEQ-DWR WQX | River/Stream | 7 mi | 44 mg/L | 18 | 2010–2025 |
| IR-169 ALLISON WOODS MW-3S REG NR TURNERSBURG, NC USGS North Carolina Water Science Center | Well | 8.8 mi | 19 mg/L | 2 | 2006–2007 |
| IR-170 ALLISON WOODS RS MW-3I TZ NR TURNERSBURG USGS North Carolina Water Science Center | Well | 8.8 mi | 26 mg/L | 2 | 2006–2007 |
| UNNAMED TRIB TO ROCKY CREEK NR TURNERSBURG, NC USGS North Carolina Water Science Center | Stream | 8.8 mi | 21 mg/L | 1 | 2007 |
Water hardness in towns near Statesville
| Town | Distance | Median | Class |
|---|---|---|---|
| Mooresville | 14 mi | 25 mg/L | Soft |
| Davidson | 21 mi | 27 mg/L | Soft |
| Cornelius | 22 mi | 23 mg/L | Soft |
| Newton | 22 mi | 15 mg/L | Soft |
| Salisbury | 23 mi | 52 mg/L | Soft |
| Kannapolis | 25 mi | 49 mg/L | Soft |
| Hickory | 25 mi | 15 mg/L | Soft |
| Huntersville | 26 mi | 28 mg/L | Soft |
| Lincolnton | 30 mi | 32 mg/L | Soft |
| Concord | 30 mi | 60 mg/L | Moderately hard |
Iredell County
Statesville is in Iredell County, where the median is 26 mg/L (soft) across 33 sites.
See all of Iredell County →North Carolina
The statewide median is 33 mg/L (soft) from 1,749 sites.
North Carolina hardness map →Statesville, NC water: common questions
Do I need a water softener in Statesville?
Probably not. Water measured around Statesville is 1.5 gpg (26 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Statesville's drinking water?
The main public water system serving Statesville in EPA records is City of Statesville. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Statesville?
It depends on what you want to remove. In Statesville, the system had 2 health-based violations since 2016, for the Lead and Copper Rule Revisions and the Interim Enhanced Surface Water Treatment Rule; the utility's annual report says what was done about them. On the other hand, no PFAS found in EPA testing and no lead service lines reported. A water softener is not a filter.How to read your water quality report →
Hardness scale
What to read next
- How to tell if your home has a lead pipe12,278 service lines here are of unknown material.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.