Water hardness in Burlington, NC

Water in Burlington is soft, with a median of 42 mg/L (2.5 grains per gallon) across 20 monitoring sites within 10 miles.

about the same as the North Carolina median (33 mg/L) 40th hardest of 92 North Carolina towns Population 60,032
42mg/L
2.5 grains per gallon
Soft

Burlington tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 42 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 2.5 gpg (2.4 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites20
Lab samples243
Sample years2000–2025
Middle 50% of sites35–53 mg/L
Groundwater (wells, springs)175 mg/L · 1 sites
Surface water (rivers, lakes)42 mg/L · 19 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Burlington

Prefilled with Burlington's measured local hardness of 42 mg/L (2.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Burlington tap water

City of Burlington is the main public water system for Burlington. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Jul 2024 – Apr 2025. 7 PFAS were detected. The highest PFOS and PFOA results were above EPA's drinking water limit (4 ppt).

ChemicalHighest resultDetected inEPA limit
PFOS
perfluorooctane sulfonic acid
17 ppt 8 of 8 samples 4 ppt
PFOA
perfluorooctanoic acid
13 ppt 7 of 8 samples 4 ppt
6:2 FTS
6:2 fluorotelomer sulfonic acid
9.7 ppt 1 of 8 samples —
PFHxA
perfluorohexanoic acid
4.4 ppt 3 of 8 samples —
PFHpA
perfluoroheptanoic acid
4.2 ppt 1 of 8 samples —
PFPeA
perfluoropentanoic acid
4.1 ppt 1 of 8 samples —
PFHxS
perfluorohexane sulfonic acid
3.2 ppt 1 of 8 samples 10 ppt*

Other water systems serving parts of Burlington

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Graham
serves over 10,000 people
PFBS, PFOA, PFOS +2 more 7.6 / 7.4 ppt Nov 2023 – Aug 2024
Town of Elon
serves over 10,000 people
PFOS, PFBA, PFOA 5.3 / 9 ppt Sep 2024 – Jun 2025
City of Greensboro
serves over 10,000 people
PFOS, PFHxS, PFHxA +6 more 5.6 / 35.6 ppt Jul 2023 – Apr 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Burlington

City of Burlington reported 25,114 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 84 are galvanized lines that must be replaced, and 1,324 are still of unknown material.

0lead (0%)
84galvanized requiring replacement
1,324unknown material (5%)
23,706not lead (94%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Burlington whether your address is on its list.

Other water systems serving parts of Burlington

Water systemService linesTotal
City of Graham0 lead · 187 galvanized · 380 unknown6,265
Town of Elon0 lead · 0 galvanized · 822 unknown2,076
City of Greensboro0 lead · 17 galvanized · 67,123 unknown109,822

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Burlington drinking water violations

EPA records show 1 health-based violation for City of Burlington since 2016, all since resolved or closed. The most recent began in Jul 2021. It also had 3 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Contaminant or ruleTypeViolationsMost recentStatus
Coliform bacteria / E. coli (Revised Total Coliform Rule)
bacteria that signal possible contamination of the system · what it means
Contaminant above legal limit 1 Jul 2021 Resolved/closed

Other water systems serving parts of Burlington

Water systemHealth-based violationsMonitoring/reporting
City of GrahamNone0
Town of ElonNone11
City of GreensboroNone3

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Burlington

SiteTypeDistanceMedianSamplesYears
LAKE MACKINTOSH
North Carolina Dept of Environmental Quality NCDEQ-DWR WQX
Lake 3.2 mi38 mg/L282008–2023
LAKE BURLINGTON
North Carolina Dept of Environmental Quality NCDEQ-DWR WQX
Lake 5 mi36 mg/L142008–2023
HAW RIV AT NC 49N AT HAW RIVER
NCDENR-DWQ (2nd)
River/Stream 5.7 mi50 mg/L82000–2001
HAW RIV AT NC 49N AT HAW RIVER
North Carolina Dept of Environmental Quality NCDEQ-DWR WQX
River/Stream 5.7 mi44 mg/L192010–2025
LAKE MACINTOSH AT NC 61 NR WHITSETT
NCDENR-DWQ (2nd)
Reservoir 5.9 mi49 mg/L52000
TOWN BRANCH AT SR 2109 NR GRAHAM
NCDENR-DWQ (2nd)
River/Stream 5.9 mi74 mg/L72000–2001

Water hardness in towns near Burlington

TownDistanceMedianClass
Elon3 mi 46 mg/LSoft
Graham5 mi 42 mg/LSoft
Mebane11 mi 36 mg/LSoft
Greensboro20 mi 48 mg/LSoft
Reidsville22 mi 46 mg/LSoft
Carrboro24 mi 41 mg/LSoft
Summerfield25 mi 30 mg/LSoft
Chapel Hill26 mi 43 mg/LSoft
High Point30 mi 44 mg/LSoft
Archdale30 mi 45 mg/LSoft

Alamance County

Burlington is in Alamance County, where the median is 42 mg/L (soft) across 22 sites.

See all of Alamance County →

North Carolina

The statewide median is 33 mg/L (soft) from 1,749 sites.

North Carolina hardness map →

Burlington, NC water: common questions

Do I need a water softener in Burlington?

Probably not. Water measured around Burlington is 2.5 gpg (42 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →

Who supplies Burlington's drinking water?

The main public water system serving Burlington in EPA records is City of Burlington. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Burlington?

It depends on what you want to remove. In Burlington, EPA testing found PFOS, PFOA and 6:2 FTS and 4 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system had 1 health-based violation since 2016, for the Revised Total Coliform Rule; the utility's annual report says what was done about it. On the other hand, no lead service lines reported. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next