Water hardness in Port Washington, NY
Water in Port Washington is soft, with a median of 52 mg/L (3 grains per gallon) across 28 monitoring sites within 10 miles.
Port Washington tap water at a glance
- HardnessSoft (52 mg/L, 3 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFAS6 found; the highest PFOA and PFOS result was above EPA's 4 ppt limit (a single result is not a violation).Filters that remove PFAS →
- Lead pipesThe water system reported 95 lead service lines.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 52 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 3 gpg (2.9 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Port Washington
Prefilled with Port Washington's measured local hardness of 52 mg/L (3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Port Washington tap water
Port Washington WD is the main public water system for Port Washington. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 18 samples taken Feb 2023 – Jun 2026. 6 PFAS were detected. The highest PFOA and PFOS results were above EPA's drinking water limit (4 ppt).
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFPeA perfluoropentanoic acid | 6.9 ppt | 3 of 18 samples | — |
| 6:2 FTS 6:2 fluorotelomer sulfonic acid | 6.5 ppt | 1 of 18 samples | — |
| PFOA perfluorooctanoic acid | 5.3 ppt | 3 of 18 samples | 4 ppt |
| PFOS perfluorooctane sulfonic acid | 4.7 ppt | 1 of 18 samples | 4 ppt |
| PFNA perfluorononanoic acid | 4.2 ppt | 1 of 18 samples | 10 ppt* |
| PFHxA perfluorohexanoic acid | 3.6 ppt | 2 of 18 samples | — |
Other water systems serving parts of Port Washington
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Manhasset Lakeville WD serves over 10,000 people | PFNA, PFPeA, PFOA +2 more | 5.3 / ND ppt | Feb 2025 – Aug 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Port Washington
Port Washington WD reported 9,440 service lines (the pipes connecting homes to the water main) in its inventory. 95 are lead and 0 are galvanized lines that must be replaced, and 2,207 are still of unknown material.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Port Washington WD whether your address is on its list.
Other water systems serving parts of Port Washington
| Water system | Service lines | Total |
|---|---|---|
| Manhasset Lakeville WD | 10 lead · 41 galvanized · 320 unknown | 10,805 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Port Washington drinking water violations
EPA records show no health-based violations for Port Washington WD since 2016.
Other water systems serving parts of Port Washington
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Manhasset Lakeville WD | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Port Washington
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| N 9902. 1 USGS New York Water Science Center | Well | 1.7 mi | 119 mg/L | 1 | 2018 |
| N 14329. 1 USGS New York Water Science Center | Well | 3.4 mi | 81 mg/L | 1 | 2017 |
| N 14330. 1 USGS New York Water Science Center | Well | 3.4 mi | 85 mg/L | 1 | 2017 |
| N 7873. 1 USGS New York Water Science Center | Well | 4.1 mi | 26 mg/L | 1 | 2016 |
| N 5762. 2 USGS New York Water Science Center | Well | 4.5 mi | 69 mg/L | 1 | 2016 |
| N 1651. 1 USGS New York Water Science Center | Well | 5 mi | 42 mg/L | 1 | 2013 |
Water hardness in towns near Port Washington
| Town | Distance | Median | Class |
|---|---|---|---|
| Great Neck | 3 mi | 63 mg/L | Moderately hard |
| Glen Cove | 4 mi | 54 mg/L | Soft |
| North New Hyde Park | 6 mi | 50 mg/L | Soft |
| Mineola | 6 mi | 44 mg/L | Soft |
| New Hyde Park | 7 mi | 51 mg/L | Soft |
| Westbury | 7 mi | 50 mg/L | Soft |
| Garden City | 7 mi | 38 mg/L | Soft |
| Floral Park | 7 mi | 44 mg/L | Soft |
| New Cassel | 8 mi | 47 mg/L | Soft |
| Jericho | 8 mi | 46 mg/L | Soft |
Nassau County
Port Washington is in Nassau County, where the median is 50 mg/L (soft) across 47 sites.
See all of Nassau County →New York
The statewide median is 77 mg/L (moderately hard) from 2,847 sites.
New York hardness map →Port Washington, NY water: common questions
Do I need a water softener in Port Washington?
Probably not. Water measured around Port Washington is 3 gpg (52 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Port Washington's drinking water?
The main public water system serving Port Washington in EPA records is Port Washington WD. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Port Washington?
It depends on what you want to remove. In Port Washington, EPA testing found PFPeA, 6:2 FTS and PFOA and 3 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system reports 95 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Which water filters remove PFAS?EPA tests found 6 PFAS in Port Washington's main water system.
- How to tell if your home has a lead pipe95 lead service lines are reported here.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.