Water hardness in Cheshire County, NH

Water in Cheshire County is soft, with a median of 16 mg/L (0.9 grains per gallon) across 24 monitoring sites.

about the same as the New Hampshire median (15 mg/L) 4th hardest of 10 counties
16mg/L
0.9 grains per gallon
Soft

Cheshire County water at a glance

  • HardnessSoft (16 mg/L, 0.9 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 16 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 0.9 gpg (0.9 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites24
Lab samples228
Sample years2000–2024
Middle 50% of sites10–26 mg/L
Groundwater (wells, springs)94 mg/L · 1 sites
Surface water (rivers, lakes)16 mg/L · 23 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Cheshire County

Prefilled with Cheshire County's measured local hardness of 16 mg/L (0.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Cheshire County on the New Hampshire map

Coos CountyGrafton CountyBelknap CountyMerrimack CountyCarroll CountyRockingham CountyStrafford CountySullivan CountyHillsborough County

Cities and communities in Cheshire County

PlaceMedian mg/LClassBased on
Keene 9 Soft 8 sites within 10 miles
Jaffrey (CDP) 14 Soft 3 sites within 10 miles
Winchester (CDP) 16 Soft 8 sites within 10 miles
Hinsdale (CDP) 19 Soft 8 sites within 10 miles
West Swanzey (CDP) 10 Soft 9 sites within 10 miles
Troy (CDP) 13 Soft 6 sites within 10 miles
Marlborough (CDP) 9 Soft 6 sites within 10 miles
North Walpole (CDP) 20 Soft 12 sites within 10 miles
Walpole (CDP) 18 Soft 12 sites within 10 miles

Water quality in Cheshire County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Keene Keene Water Dept None detected 0 lead · 0 unknown None
Jaffrey Jaffrey Water Works 3 found (PFOA 6.6 / PFOS 5.6 ppt) 0 lead · 1,426 unknown None
Winchester Winchester Water Dept Not tested 0 lead · 701 unknown None
Hinsdale North Hinsdale Water Dept Not tested 0 lead · 511 unknown None
West Swanzey West Swanzey Water Not tested 0 lead · 53 unknown 1
Troy Troy Water Works Not tested 0 lead · 430 unknown None
Marlborough Marlborough Water Works Not tested 0 lead · 240 unknown None
Walpole Walpole Water Dept Not tested 0 lead · 383 unknown None

Neighboring counties

New Hampshire

The statewide median is 15 mg/L (soft) from 330 sites.

New Hampshire hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next