Water hardness in Belknap County, NH

Water in Belknap County is soft, with a median of 14 mg/L (0.8 grains per gallon) across 8 monitoring sites.

about the same as the New Hampshire median (15 mg/L) 7th hardest of 10 counties
14mg/L
0.8 grains per gallon
Soft

Belknap County water at a glance

  • HardnessSoft (14 mg/L, 0.8 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 14 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 0.8 gpg (0.8 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites8
Lab samples48
Sample years2000–2021
Middle 50% of sites9–26 mg/L
Groundwater (wells, springs)23 mg/L · 2 sites
Surface water (rivers, lakes)10 mg/L · 6 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Belknap County

Prefilled with Belknap County's measured local hardness of 14 mg/L (0.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Belknap County on the New Hampshire map

Coos CountyGrafton CountyMerrimack CountyCarroll CountyRockingham CountyCheshire CountyStrafford CountySullivan CountyHillsborough County

Cities and communities in Belknap County

PlaceMedian mg/LClassBased on
Laconia 18 Soft 5 sites within 10 miles
Tilton Northfield (CDP) 22 Soft 10 sites within 10 miles
Meredith (CDP) 26 Soft 4 sites within 10 miles
Belmont (CDP) 14 Soft 11 sites within 10 miles
Alton (CDP) 10 Soft 4 sites within 10 miles
New Hampton (CDP) 8 Soft 8 sites within 10 miles

Water quality in Belknap County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Laconia Laconia Water Works None detected 0 lead · 177 unknown None
Meredith Meredith Water Dept Not tested 0 lead · 958 unknown 3
Belmont Belmont Water Dept Not tested 0 lead · 569 unknown None
Alton Alton Water Works Not tested 0 lead · 259 unknown 2
New Hampton New Hampton Village PCT Not tested 0 lead · 138 unknown 50

Neighboring counties

New Hampshire

The statewide median is 15 mg/L (soft) from 330 sites.

New Hampshire hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next