Water hardness in Lake County, MN
Water in Lake County is soft, with a median of 24 mg/L (1.4 grains per gallon) across 69 monitoring sites.
Lake County water at a glance
- HardnessSoft (24 mg/L, 1.4 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 24 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.4 gpg (1.3 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Lake County
Prefilled with Lake County's measured local hardness of 24 mg/L (1.4 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Lake County on the Minnesota map
Cities and communities in Lake County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Two Harbors | 24 | Soft | county median |
| Silver Bay | 66 | Moderately hard | 11 sites within 10 miles |
| Finland (CDP) | 24 | Soft | county median |
| Beaver Bay | 66 | Moderately hard | 11 sites within 10 miles |
| Knife River (CDP) | 109 | Moderately hard | 4 sites within 10 miles |
Water quality in Lake County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Two Harbors | Two Harbors | None detected | 8 lead · 1,348 unknown | None |
| Silver Bay | Silver Bay | Not tested | 0 lead · 1,068 unknown | None |
| Beaver Bay | Beaver Bay | Not tested | 0 lead · 2 unknown | None |
Neighboring counties
- St. Louis County60 mg/L
- Cook County21 mg/L
- Carlton County50 mg/L
- Itasca County116 mg/L
- Aitkin County63 mg/L
- Pine County56 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.