Water hardness in Columbia Heights, MN

Water in Columbia Heights is very hard, with a median of 200 mg/L (11.7 grains per gallon) across 116 monitoring sites within 10 miles.

about the same as the Minnesota median (190 mg/L) 69th hardest of 102 Minnesota towns Population 22,278
200mg/L
11.7 grains per gallon
Very hard

Columbia Heights tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 200 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 11.7 gpg (11.2 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites116
Lab samples5,272
Sample years2000–2025
Middle 50% of sites130–393 mg/L
Groundwater (wells, springs)429 mg/L · 42 sites
Surface water (rivers, lakes)152 mg/L · 74 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Columbia Heights

Prefilled with Columbia Heights's measured local hardness of 200 mg/L (11.7 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Columbia Heights tap water

The City of Columbia Heights water system is the main public water system for Columbia Heights. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Mar 2025 – Dec 2025. 1 PFAS was detected.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
12.4 ppt 4 of 4 samples —

Other water systems serving parts of Columbia Heights

Water systemPFAS detectedHighest PFOA / PFOSTested
Minneapolis
serves over 10,000 people
PFBA — May 2023 – Jul 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Columbia Heights

The City of Columbia Heights water system reported 6,670 service lines (the pipes connecting homes to the water main) in its inventory. 1 are lead and 285 are galvanized lines that must be replaced, and 367 are still of unknown material.

1lead (<1%)
285galvanized requiring replacement
367unknown material (6%)
6,017not lead (90%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask the City of Columbia Heights water system whether your address is on its list.

Other water systems serving parts of Columbia Heights

Water systemService linesTotal
Minneapolis38,341 lead · 132 galvanized · 962 unknown100,414

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Columbia Heights drinking water violations

EPA records show no health-based violations for the City of Columbia Heights water system since 2016. It also had 3 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Columbia Heights

Water systemHealth-based violationsMonitoring/reporting
MinneapolisNone1

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Columbia Heights

SiteTypeDistanceMedianSamplesYears
SANDY (SULLIVAN)
Minnesota Pollution Control Agency - Ambient Surface Water (State)
Lake 1 mi55 mg/L12023
SILVER
Minnesota Pollution Control Agency - Ambient Surface Water (State)
Lake 1.1 mi88 mg/L1772000–2011
MISSISSIPPI RIVER BELOW I-694 AT FRIDLEY, MN
USGS Minnesota Water Science Center
Stream 1.5 mi178 mg/L52005
MISSISSIPPI R MPLS CITY BUILDING AT FRIDLEY
Minnesota Pollution Control Agency - Ambient Surface Water (State)
River/Stream 1.6 mi198 mg/L11952009–2012
MISSISSIPPI RIVER AT NORTH MISSISSIPPI REGIONAL PARK
Minnesota Pollution Control Agency - Ambient Surface Water (State)
River/Stream 1.7 mi234 mg/L442024–2025
MOORE (EAST BAY)
Minnesota Pollution Control Agency - Ambient Surface Water (State)
Lake 1.9 mi66 mg/L92010–2011

Water hardness in towns near Columbia Heights

TownDistanceMedianClass
New Brighton2 mi 180 mg/LHard
Fridley3 mi 220 mg/LVery hard
Brooklyn Center4 mi 221 mg/LVery hard
Mounds View4 mi 198 mg/LVery hard
Robbinsdale4 mi 221 mg/LVery hard
Roseville5 mi 170 mg/LHard
Crystal6 mi 285 mg/LVery hard
Shoreview6 mi 166 mg/LHard
Minneapolis6 mi 216 mg/LVery hard
Brooklyn Park7 mi 292 mg/LVery hard

Anoka County

Columbia Heights is in Anoka County, where the median is 235 mg/L (very hard) across 23 sites.

See all of Anoka County →

Minnesota

The statewide median is 190 mg/L (very hard) from 2,553 sites.

Minnesota hardness map →

Columbia Heights, MN water: common questions

Do I need a water softener in Columbia Heights?

Very likely. Water measured around Columbia Heights is 11.7 gpg (200 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 21,000 grains.Size it for your household →

Who supplies Columbia Heights's drinking water?

The main public water system serving Columbia Heights in EPA records is Columbia Heights. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Columbia Heights?

It depends on what you want to remove. In Columbia Heights, EPA testing found PFBA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system reports 1 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next