Water hardness in Sterling Heights, MI

Water in Sterling Heights is very hard, with a median of 268 mg/L (15.7 grains per gallon) across 9 monitoring sites within 10 miles.

79% harder than the Michigan median (150 mg/L) 50th hardest of 101 Michigan towns Population 133,306
268mg/L
15.7 grains per gallon
Very hard

Large city utilities sometimes soften, blend or import water from distant reservoirs, so tap water in Sterling Heights can differ from local source water. Your utility's annual Consumer Confidence Report lists the exact tap value.

Sterling Heights tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 268 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 15.7 gpg (15 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites9
Lab samples485
Sample years2000–2023
Middle 50% of sites220–296 mg/L
Groundwater (wells, springs)498 mg/L · 2 sites
Surface water (rivers, lakes)250 mg/L · 7 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Sterling Heights

Prefilled with Sterling Heights's measured local hardness of 268 mg/L (15.7 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Sterling Heights tap water

City of Sterling Heights is the main public water system for Sterling Heights. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Mar 2023 – Dec 2023. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Sterling Heights

City of Sterling Heights reported 39,895 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 1,995 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
1,995unknown material (5%)
37,900not lead (95%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Sterling Heights drinking water violations

EPA records show no health-based violations for City of Sterling Heights since 2016.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Sterling Heights

SiteTypeDistanceMedianSamplesYears
CLINTON RIVER AT STERLING HEIGHTS, MI
USGS Michigan Water Science Center
Stream 2.3 mi268 mg/L2642001–2023
RED RUN AT 14 MILE ROAD AT WARREN, MI
USGS Michigan Water Science Center
Stream 3.2 mi183 mg/L32005–2006
CLINTON RIVER AT MORAVIAN DRIVE AT MT. CLEMENS, MI
USGS Michigan Water Science Center
Stream 6.3 mi170 mg/L162011–2014
CLINTON RIVER AT AVON ROAD AT YATES, MI
USGS Michigan Water Science Center
Stream 7.1 mi271 mg/L172001–2003
CLINTON RIVER AT GRATIOT AVENUE AT MT. CLEMENS, MI
USGS Michigan Water Science Center
Stream 7.5 mi250 mg/L1622000–2013
URB125-19b
USGS Michigan Water Science Center
Well 8.6 mi470 mg/L22007–2016

Water hardness in towns near Sterling Heights

TownDistanceMedianClass
Fraser5 mi 216 mg/LVery hard
Troy6 mi 268 mg/LVery hard
Warren6 mi 105 mg/LModerately hard
Madison Heights6 mi 304 mg/LVery hard
Clawson7 mi 340 mg/LVery hard
Roseville7 mi 216 mg/LVery hard
Mount Clemens8 mi 250 mg/LVery hard
Royal Oak8 mi 304 mg/LVery hard
Rochester9 mi 258 mg/LVery hard
Rochester Hills9 mi 258 mg/LVery hard

Macomb County

Sterling Heights is in Macomb County, where the median is 282 mg/L (very hard) across 16 sites.

See all of Macomb County →

Michigan

The statewide median is 150 mg/L (hard) from 1,435 sites.

Michigan hardness map →

Sterling Heights, MI water: common questions

Do I need a water softener in Sterling Heights?

Very likely. Water measured around Sterling Heights is 15.7 gpg (268 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 28,000 grains.Size it for your household →

Who supplies Sterling Heights's drinking water?

The main public water system serving Sterling Heights in EPA records is City of Sterling Heights. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Sterling Heights?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next