Water hardness in Severn, MD

Water in Severn is soft, with a median of 23 mg/L (1.4 grains per gallon) across 23 monitoring sites within 10 miles.

59% softer than the Maryland median (56 mg/L) 106th hardest of 121 Maryland towns Population 44,231 (2010)
23mg/L
1.4 grains per gallon
Soft

Severn tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 23 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1.4 gpg (1.3 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites23
Lab samples25
Sample years2000–2019
Middle 50% of sites14–63 mg/L
Groundwater (wells, springs)16 mg/L · 19 sites
Surface water (rivers, lakes)112 mg/L · 4 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Severn

Prefilled with Severn's measured local hardness of 23 mg/L (1.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Severn tap water

Severn Water Company is the main public water system for Severn. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 2 samples taken Jun 2024 – Dec 2024. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Severn

Water systemPFAS detectedHighest PFOA / PFOSTested
Glen Burnie-Broadneck
serves over 10,000 people
None detected — Nov 2024 – May 2025
Crofton-Odenton
serves over 10,000 people
None detected — Jun 2024 – Nov 2024
Fort George G. Meade
serves over 10,000 people
None detected — Apr 2023 – Oct 2023

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Severn

Maryland American Water--Severn System reported 202 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 202 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
202unknown material (100%)
0not lead (0%)

Other water systems serving parts of Severn

Water systemService linesTotal
Glen Burnie-Broadneck0 lead · 48 galvanized · 8,124 unknown8,172
Crofton-Odenton0 lead · 0 galvanized · 616 unknown616
Fort George G. Meade0 lead · 88 galvanized · 144 unknown232

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Severn drinking water violations

EPA records show no health-based violations for Severn Water Company since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Severn

Water systemHealth-based violationsMonitoring/reporting
Glen Burnie-BroadneckNone12
Crofton-OdentonNone2
Fort George G. MeadeNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Severn

SiteTypeDistanceMedianSamplesYears
AA Bc 209
USGS Maryland Water Science Center
Well 1.3 mi5 mg/L12016
AA Bc 252
USGS Maryland Water Science Center
Well 1.4 mi55 mg/L12003
AA Bc 253
USGS Maryland Water Science Center
Well 3.1 mi14 mg/L12003
AA Bd 126
USGS Maryland Water Science Center
Well 3.4 mi49 mg/L12003
AA Bb 86
USGS Maryland Water Science Center
Well 3.7 mi24 mg/L12009
AA Bb 87
USGS Maryland Water Science Center
Well 3.7 mi16 mg/L12009

Water hardness in towns near Severn

TownDistanceMedianClass
Odenton5 mi 23 mg/LSoft
Elkridge5 mi 49 mg/LSoft
Ferndale5 mi 39 mg/LSoft
Glen Burnie5 mi 25 mg/LSoft
Linthicum5 mi 39 mg/LSoft
Maryland City6 mi 16 mg/LSoft
Ilchester7 mi 50 mg/LSoft
Brooklyn Park7 mi 73 mg/LModerately hard
Arbutus7 mi 55 mg/LSoft
Pasadena7 mi 37 mg/LSoft

Anne Arundel County

Severn is in Anne Arundel County, where the median is 95 mg/L (moderately hard) across 57 sites.

See all of Anne Arundel County →

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Severn, MD water: common questions

Do I need a water softener in Severn?

Probably not. Water measured around Severn is 1.4 gpg (23 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →

Who supplies Severn's drinking water?

The main public water system serving Severn in EPA records is Severn Water Company. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Severn?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next