Water hardness in Cloverly, MD

Water in Cloverly is moderately hard, with a median of 92 mg/L (5.4 grains per gallon) across 8 monitoring sites within 10 miles.

64% harder than the Maryland median (56 mg/L) 50th hardest of 121 Maryland towns Population 15,126 (2010)
92mg/L
5.4 grains per gallon
Moderately hard

Cloverly tap water at a glance

  • HardnessModerately hard (92 mg/L, 5.4 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 92 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.4 gpg (5.2 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites8
Lab samples16
Sample years2003–2019
Middle 50% of sites67–120 mg/L
Groundwater (wells, springs)92 mg/L · 8 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Cloverly

Prefilled with Cloverly's measured local hardness of 92 mg/L (5.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Cloverly tap water

Cloverly is served by more than one water system. These systems supply ZIP codes in Cloverly and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Cloverly

Water systemPFAS detectedHighest PFOA / PFOSTested
Washington Suburban Sanitary Commission
serves over 10,000 people
PFPeA, PFHxA — Mar 2023 – Jun 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Cloverly

Cloverly is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Cloverly

Water systemService linesTotal
Washington Suburban Sanitary Commission8 lead · 1,277 galvanized · 57,121 unknown58,406

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Cloverly drinking water violations

Cloverly is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Cloverly

Water systemHealth-based violationsMonitoring/reporting
Washington Suburban Sanitary CommissionNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Cloverly

SiteTypeDistanceMedianSamplesYears
MO Dg 34
USGS Maryland Water Science Center
Well 2.4 mi108 mg/L92003–2019
MO Df 61
USGS Maryland Water Science Center
Well 5.4 mi177 mg/L12003
HO Cd 206
USGS Maryland Water Science Center
Well 5.8 mi77 mg/L12019
MO Ff 19
USGS Maryland Water Science Center
Well 8.8 mi158 mg/L12014
HO De 51
USGS Maryland Water Science Center
Well 9.1 mi71 mg/L12019
MO Cf 27
USGS Maryland Water Science Center
Well 9.3 mi55 mg/L12014

Water hardness in towns near Cloverly

TownDistanceMedianClass
Colesville2 mi 106 mg/LModerately hard
Fairland3 mi 60 mg/LModerately hard
Glenmont4 mi 172 mg/LHard
Calverton4 mi 90 mg/LModerately hard
White Oak4 mi 164 mg/LHard
Kemp Mill5 mi 172 mg/LHard
Aspen Hill5 mi 108 mg/LModerately hard
Olney5 mi 107 mg/LModerately hard
Wheaton5 mi 177 mg/LHard
Beltsville6 mi 54 mg/LSoft

Montgomery County

Cloverly is in Montgomery County, where the median is 139 mg/L (hard) across 38 sites.

See all of Montgomery County →

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next