Water hardness in Olney, MD
Water in Olney is moderately hard, with a median of 107 mg/L (6.3 grains per gallon) across 16 monitoring sites within 10 miles.
Olney tap water at a glance
- HardnessModerately hard (107 mg/L, 6.3 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 107 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 6.3 gpg (6 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Olney
Prefilled with Olney's measured local hardness of 107 mg/L (6.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Olney tap water
Olney is served by more than one water system. These systems supply ZIP codes in Olney and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.
Water systems serving Olney
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Washington Suburban Sanitary Commission serves over 10,000 people | PFPeA, PFHxA | — | Mar 2023 – Jun 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Olney
Olney is served by more than one water system. Their service line inventories, as reported to EPA:
Water systems serving Olney
| Water system | Service lines | Total |
|---|---|---|
| Washington Suburban Sanitary Commission | 8 lead · 1,277 galvanized · 57,121 unknown | 58,406 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Olney drinking water violations
Olney is served by more than one water system. Health-based violations recorded by EPA since 2016:
Water systems serving Olney
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Washington Suburban Sanitary Commission | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Olney
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| MO Df 61 USGS Maryland Water Science Center | Well | 0.9 mi | 177 mg/L | 1 | 2003 |
| MO Dg 34 USGS Maryland Water Science Center | Well | 3.4 mi | 108 mg/L | 9 | 2003–2019 |
| MO Cf 27 USGS Maryland Water Science Center | Well | 4.3 mi | 55 mg/L | 1 | 2014 |
| HO Cd 206 USGS Maryland Water Science Center | Well | 5.7 mi | 77 mg/L | 1 | 2019 |
| MO Ce 24 USGS Maryland Water Science Center | Well | 6 mi | 36 mg/L | 2 | 2003–2015 |
| MO Ce 23 USGS Maryland Water Science Center | Well | 6.9 mi | 19 mg/L | 1 | 2003 |
Water hardness in towns near Olney
| Town | Distance | Median | Class |
|---|---|---|---|
| Aspen Hill | 4 mi | 108 mg/L | Moderately hard |
| Redland | 4 mi | 108 mg/L | Moderately hard |
| Cloverly | 5 mi | 92 mg/L | Moderately hard |
| Glenmont | 5 mi | 172 mg/L | Hard |
| Rockville | 6 mi | 156 mg/L | Hard |
| Colesville | 6 mi | 106 mg/L | Moderately hard |
| Wheaton | 7 mi | 177 mg/L | Hard |
| Gaithersburg | 7 mi | 108 mg/L | Moderately hard |
| Kemp Mill | 8 mi | 172 mg/L | Hard |
| Fairland | 8 mi | 60 mg/L | Moderately hard |
Montgomery County
Olney is in Montgomery County, where the median is 139 mg/L (hard) across 38 sites.
See all of Montgomery County →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.