Water hardness in Somerset County, ME

Water in Somerset County is soft, with a median of 54 mg/L (3.2 grains per gallon) across 17 monitoring sites.

about the same as the Maine median (44 mg/L) 6th hardest of 15 counties
54mg/L
3.2 grains per gallon
Soft

Somerset County water at a glance

  • HardnessSoft (54 mg/L, 3.2 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 54 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 3.2 gpg (3 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites17
Lab samples35
Sample years2000–2019
Middle 50% of sites13–100 mg/L
Groundwater (wells, springs)96 mg/L · 11 sites
Surface water (rivers, lakes)13 mg/L · 6 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Somerset County

Prefilled with Somerset County's measured local hardness of 54 mg/L (3.2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Somerset County on the Maine map

Aroostook CountyYork CountyHancock CountyWashington CountyKnox CountyOxford CountyAndroscoggin CountySagadahoc CountyFranklin CountyKennebec CountyWaldo CountyPiscataquis CountyPenobscot CountyLincoln CountyCumberland County

Cities and communities in Somerset County

PlaceMedian mg/LClassBased on
Skowhegan (CDP) 62 Moderately hard 8 sites within 10 miles
Pittsfield (CDP) 54 Soft county median
Fairfield (CDP) 72 Moderately hard 9 sites within 10 miles
Madison (CDP) 83 Moderately hard 6 sites within 10 miles
Norridgewock (CDP) 83 Moderately hard 10 sites within 10 miles
Hartland (CDP) 54 Soft county median
Bingham (CDP) 14 Soft 4 sites within 10 miles
Anson (CDP) 66 Moderately hard 3 sites within 10 miles
North Anson (CDP) 54 Soft county median

Water quality in Somerset County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Skowhegan Maine Water Company Skowhegan Division None detected 0 lead · 0 unknown None
Pittsfield Pittsfield Water Dept Not tested 0 lead · 941 unknown 2
Fairfield Kennebec Water District 4 found (PFOA 6.4 / PFOS ND ppt) 0 lead · 0 unknown None
Madison Anson and Madison Water District None detected 0 lead · 752 unknown None
Norridgewock Norridgewock Water District Not tested 0 lead · 5 unknown None
Hartland Maine Water Company Hartland Division Not tested 0 lead · 0 unknown None
Bingham Bingham Water District Not tested 0 lead · 113 unknown 1
Anson Anson and Madison Water District None detected 0 lead · 752 unknown None

Neighboring counties

Maine

The statewide median is 44 mg/L (soft) from 251 sites.

Maine hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next