Water hardness in Washington County, ME

Water in Washington County is soft, with a median of 16 mg/L (1 grains per gallon) across 4 monitoring sites.

64% softer than the Maine median (44 mg/L) 10th hardest of 15 counties
16mg/L
1 grains per gallon
Soft

Washington County water at a glance

  • HardnessSoft (16 mg/L, 1 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 16 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1 gpg (0.9 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites4
Lab samples6
Sample years2001–2023
Middle 50% of sites12–36 mg/L
Groundwater (wells, springs)86 mg/L · 1 sites
Surface water (rivers, lakes)13 mg/L · 3 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Washington County

Prefilled with Washington County's measured local hardness of 16 mg/L (0.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Washington County on the Maine map

Aroostook CountyYork CountyHancock CountyKnox CountyOxford CountyAndroscoggin CountySagadahoc CountyFranklin CountySomerset CountyKennebec CountyWaldo CountyPiscataquis CountyPenobscot CountyLincoln CountyCumberland County

Cities and communities in Washington County

PlaceMedian mg/LClassBased on
Calais 16 Soft county median
Eastport 16 Soft county median
Machias (CDP) 16 Soft county median
Woodland (CDP) 16 Soft county median
Lubec (CDP) 16 Soft county median
Danforth (CDP) 16 Soft county median
Jonesport (CDP) 16 Soft county median
Milbridge (CDP) 16 Soft county median
Vanceboro (CDP) 16 Soft county median

Water quality in Washington County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Calais Calais Water Dept Not tested 0 lead · 1,018 unknown 1
Eastport Passamaquoddy Water District Not tested 0 lead · 0 unknown 7
Machias Machias Water Company Not tested 0 lead · 17 unknown None
Lubec Lubec Water District Not tested 0 lead · 316 unknown None
Danforth Danforth Water District Not tested 0 lead · 28 unknown None
Jonesport US Coast Guard Station-Jonesport Not tested 0 lead · 0 unknown 18
Milbridge Milbridge Water District Not tested 0 lead · 0 unknown None

Neighboring counties

Maine

The statewide median is 44 mg/L (soft) from 251 sites.

Maine hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next