Water hardness in Oxford County, ME

Water in Oxford County is soft, with a median of 8 mg/L (0.4 grains per gallon) across 16 monitoring sites.

82% softer than the Maine median (44 mg/L) 14th hardest of 15 counties
8mg/L
0.4 grains per gallon
Soft

Oxford County water at a glance

  • HardnessSoft (8 mg/L, 0.4 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 8 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 0.4 gpg (0.4 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites16
Lab samples448
Sample years2000–2023
Middle 50% of sites4–41 mg/L
Groundwater (wells, springs)49 mg/L · 6 sites
Surface water (rivers, lakes)4 mg/L · 10 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Oxford County

Prefilled with Oxford County's measured local hardness of 8 mg/L (0.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Oxford County on the Maine map

Aroostook CountyYork CountyHancock CountyWashington CountyKnox CountyAndroscoggin CountySagadahoc CountyFranklin CountySomerset CountyKennebec CountyWaldo CountyPiscataquis CountyPenobscot CountyLincoln CountyCumberland County

Cities and communities in Oxford County

PlaceMedian mg/LClassBased on
Rumford (CDP) 8 Soft county median
Norway (CDP) 8 Soft county median
South Paris (CDP) 8 Soft county median
Mexico (CDP) 8 Soft county median
Fryeburg (CDP) 8 Soft county median
Oxford (CDP) 51 Soft 3 sites within 10 miles
Dixfield (CDP) 8 Soft county median
Bethel (CDP) 24 Soft 4 sites within 10 miles

Water quality in Oxford County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Rumford Rumford Water District None detected 0 lead · 1,294 unknown None
Norway Norway Water District Not tested 4 lead · 289 unknown None
Mexico Mexico Water District Not tested 0 lead · 813 unknown None
Fryeburg Fryeburg Water Company Not tested 0 lead · 0 unknown None
Oxford Oxford Water District Not tested 0 lead · 150 unknown 1
Dixfield Dixfield Water & Sewer Dept Not tested 0 lead · 632 unknown None
Bethel Bethel Water District Not tested 0 lead · 0 unknown None

Neighboring counties

Maine

The statewide median is 44 mg/L (soft) from 251 sites.

Maine hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next