Water hardness in Auburn, ME
Water in Auburn is soft, with a median of 57 mg/L (3.4 grains per gallon) across 6 monitoring sites within 10 miles.
Auburn tap water at a glance
- HardnessSoft (57 mg/L, 3.4 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo known lead lines; 3,373 lines are still of unknown material.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 57 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 3.4 gpg (3.2 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Auburn
Prefilled with Auburn's measured local hardness of 57 mg/L (3.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Auburn tap water
Auburn Water District is the main public water system for Auburn. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Sep 2023 – Jul 2024. No PFAS were found at or above EPA's minimum reporting levels.
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Auburn
Auburn Water District reported 6,214 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 3,373 lines are still of unknown material.
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Auburn drinking water violations
EPA records show no health-based violations for Auburn Water District since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Auburn
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| ME-ANW1135 Poland, Maine USGS Maine Water Science Center | Well | 5.7 mi | 60 mg/L | 5 | 2001–2003 |
| ME-ANW1136 HHID 077 HETLID B027283 RECRUITID 114 USGS Maine Water Science Center | Well | 6 mi | 38 mg/L | 1 | 2007 |
| ME-ANW 1132 USGS Maine Water Science Center | Well | 6.5 mi | 87 mg/L | 2 | 2000–2011 |
| ME-ANW 1157 USGS Maine Water Science Center | Well | 9 mi | 38 mg/L | 2 | 2014–2023 |
| ME-CW 2024 USGS Maine Water Science Center | Well | 9.1 mi | 67 mg/L | 1 | 2000 |
| ME-ANW 1130 USGS Maine Water Science Center | Well | 9.6 mi | 54 mg/L | 1 | 2011 |
Water hardness in towns near Auburn
| Town | Distance | Median | Class |
|---|---|---|---|
| Lewiston | 4 mi | 60 mg/L | Moderately hard |
| Brunswick | 20 mi | 24 mg/L | Soft |
| Westbrook | 27 mi | 41 mg/L | Soft |
| Augusta | 31 mi | 49 mg/L | Soft |
| Portland | 31 mi | 43 mg/L | Soft |
| South Portland | 31 mi | 50 mg/L | Soft |
| Saco | 39 mi | 46 mg/L | Soft |
| Waterville | 43 mi | 68 mg/L | Moderately hard |
| Biddeford | 45 mi | 87 mg/L | Moderately hard |
| Sanford | 52 mi | 44 mg/L | Soft |
Androscoggin County
Auburn is in Androscoggin County, where the median is 53 mg/L (soft) across 10 sites.
See all of Androscoggin County →Auburn, ME water: common questions
Do I need a water softener in Auburn?
Probably not. Water measured around Auburn is 3.4 gpg (57 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Auburn's drinking water?
The main public water system serving Auburn in EPA records is Auburn Water District. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Auburn?
Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →
Hardness scale
What to read next
- How to tell if your home has a lead pipe3,373 service lines here are of unknown material.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.