Water hardness in Augusta, ME

Water in Augusta is soft, with a median of 49 mg/L (2.9 grains per gallon) across 21 monitoring sites within 10 miles.

about the same as the Maine median (44 mg/L) 7th hardest of 12 Maine towns Population 19,102
49mg/L
2.9 grains per gallon
Soft

Augusta tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 49 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 2.9 gpg (2.7 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites21
Lab samples34
Sample years2000–2007
Middle 50% of sites38–59 mg/L
Groundwater (wells, springs)50 mg/L · 20 sites
Surface water (rivers, lakes)16 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Augusta

Prefilled with Augusta's measured local hardness of 49 mg/L (2.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Augusta tap water

Greater Augusta Utility District is the main public water system for Augusta. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 2 samples taken Jun 2025 – Dec 2025. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Augusta

Greater Augusta Utility District reported 5,667 service lines (the pipes connecting homes to the water main) in its inventory. 9 are lead and 89 are galvanized lines that must be replaced, and 229 are still of unknown material.

9lead (<1%)
89galvanized requiring replacement
229unknown material (4%)
5,340not lead (94%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Greater Augusta Utility District whether your address is on its list.

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Augusta drinking water violations

EPA records show no health-based violations for Greater Augusta Utility District since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Augusta

SiteTypeDistanceMedianSamplesYears
ME-KW900 HHID 023 HETLID B024859 RECRUITID 005
USGS Maine Water Science Center
Well 3.5 mi51 mg/L12006
ME-KW915 HHID 049 HETLID C004308 RECRUITID 104
USGS Maine Water Science Center
Well 3.5 mi355 mg/L22007
ME-KW916 HHID 056 HETLID B024890 RECRUITID 082
USGS Maine Water Science Center
Well 5.6 mi61 mg/L12006
ME-KW920 HHID 065 HETLID B026994 RECRUITID 004
USGS Maine Water Science Center
Well 5.8 mi110 mg/L12007
ME-KW922 HHID 071 HETLID B026992 RECRUITID 108
USGS Maine Water Science Center
Well 6.4 mi56 mg/L12007
ME-KW926 HHID 100 HETLID B027278 RECRUITID 139
USGS Maine Water Science Center
Well 6.7 mi46 mg/L22007

Water hardness in towns near Augusta

TownDistanceMedianClass
Waterville15 mi 68 mg/LModerately hard
Lewiston28 mi 60 mg/LModerately hard
Auburn31 mi 57 mg/LSoft
Brunswick33 mi 24 mg/LSoft
Westbrook53 mi 41 mg/LSoft
Portland53 mi 43 mg/LSoft
South Portland56 mi 50 mg/LSoft
Bangor58 mi 93 mg/LModerately hard
Saco65 mi 46 mg/LSoft
Biddeford70 mi 87 mg/LModerately hard

Kennebec County

Augusta is in Kennebec County, where the median is 59 mg/L (soft) across 45 sites.

See all of Kennebec County →

Maine

The statewide median is 44 mg/L (soft) from 251 sites.

Maine hardness map →

Augusta, ME water: common questions

Do I need a water softener in Augusta?

Probably not. Water measured around Augusta is 2.9 gpg (49 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →

Who supplies Augusta's drinking water?

The main public water system serving Augusta in EPA records is Greater Augusta Utility District. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Augusta?

It depends on what you want to remove. In Augusta, the system reports 9 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no PFAS found in EPA testing and no health-based violations since 2016. A water softener is not a filter.Check your own service line →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next