Water hardness in Saco, ME

Water in Saco is soft, with a median of 46 mg/L (2.7 grains per gallon) across 9 monitoring sites within 10 miles.

about the same as the Maine median (44 mg/L) 8th hardest of 12 Maine towns Population 20,960
46mg/L
2.7 grains per gallon
Soft

Saco tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 46 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 2.7 gpg (2.6 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites9
Lab samples12
Sample years2006–2011
Middle 50% of sites29–56 mg/L
Groundwater (wells, springs)46 mg/L · 9 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Saco

Prefilled with Saco's measured local hardness of 46 mg/L (2.7 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Saco tap water

Maine Water Company Biddeford Saco Div is the main public water system for Saco. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Aug 2024 – Jun 2025. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Saco

Maine Water Company Biddeford Saco Div reported 17,496 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
17,496not lead (100%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Saco drinking water violations

EPA records show 1 health-based violation for Maine Water Company Biddeford Saco Div since 2016, all since resolved or closed. The most recent began in Aug 2021.

Contaminant or ruleTypeViolationsMost recentStatus
Surface water treatment (filtration/turbidity)
filtration requirements that protect against microbes such as Cryptosporidium
Treatment requirement not met 1 Aug 2021 Resolved/closed

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Saco

SiteTypeDistanceMedianSamplesYears
ME-YW863 HHID 073 HETLID B026890 RECRUITID 079
USGS Maine Water Science Center
Well 5 mi53 mg/L12007
ME-YW860 HHID 031 HETLID B024879 RECRUITID 077
USGS Maine Water Science Center
Well 5.3 mi29 mg/L12006
ME-YW862 HHID 070 HETLID B026999 RECRUITID 110
USGS Maine Water Science Center
Well 5.7 mi92 mg/L22007
ME-CW2037 HHID 051 HETLID B024868 RECRUITID 026
USGS Maine Water Science Center
Well 6.3 mi17 mg/L12006
ME-CW2034 HHID 037 HETLID B026996 RECRUITID 002
USGS Maine Water Science Center
Well 7 mi46 mg/L12006
ME-CW2040 HHID 059 HETLID B026952 RECRUITID 043
USGS Maine Water Science Center
Well 7.1 mi40 mg/L12007

Water hardness in towns near Saco

TownDistanceMedianClass
Biddeford6 mi 87 mg/LModerately hard
South Portland10 mi 50 mg/LSoft
Westbrook13 mi 41 mg/LSoft
Portland14 mi 43 mg/LSoft
Sanford18 mi 44 mg/LSoft
Brunswick34 mi 24 mg/LSoft
Auburn39 mi 57 mg/LSoft
Lewiston41 mi 60 mg/LModerately hard
Augusta65 mi 49 mg/LSoft
Waterville80 mi 68 mg/LModerately hard

York County

Saco is in York County, where the median is 52 mg/L (soft) across 14 sites.

See all of York County →

Maine

The statewide median is 44 mg/L (soft) from 251 sites.

Maine hardness map →

Saco, ME water: common questions

Do I need a water softener in Saco?

Probably not. Water measured around Saco is 2.7 gpg (46 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →

Who supplies Saco's drinking water?

The main public water system serving Saco in EPA records is Maine Water Company Biddeford Saco Div. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Saco?

It depends on what you want to remove. In Saco, the system had 1 health-based violation since 2016, for the Interim Enhanced Surface Water Treatment Rule; the utility's annual report says what was done about it. On the other hand, no PFAS found in EPA testing and no lead service lines reported. A water softener is not a filter.How to read your water quality report →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next