Water hardness in Milford, DE

Water in Milford is soft, with a median of 47 mg/L (2.7 grains per gallon) across 82 monitoring sites within 10 miles.

about the same as the Delaware median (53 mg/L) 11th hardest of 11 Delaware towns Population 13,289
47mg/L
2.7 grains per gallon
Soft

Milford tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 47 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 2.7 gpg (2.6 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites82
Lab samples3,617
Sample years2000–2025
Middle 50% of sites36–60 mg/L
Groundwater (wells, springs)47 mg/L · 23 sites
Surface water (rivers, lakes)45 mg/L · 59 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Milford

Prefilled with Milford's measured local hardness of 47 mg/L (2.7 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Milford tap water

Milford Water Department is the main public water system for Milford. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 10 samples taken Jan 2025 – Jul 2025. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Milford

Milford Water Department reported 5,202 service lines (the pipes connecting homes to the water main) in its inventory. 3 are lead and 114 are galvanized lines that must be replaced, and 2,740 are still of unknown material.

3lead (<1%)
114galvanized requiring replacement
2,740unknown material (53%)
2,345not lead (45%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Milford Water Department whether your address is on its list.

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Milford drinking water violations

EPA records show 1 health-based violation for Milford Water Department since 2016, all since resolved or closed. The most recent began in Jun 2020.

Contaminant or ruleTypeViolationsMost recentStatus
Fluoride
naturally occurring or added; above the federal limit
highest measured 0.777 MG/L; limit 4.0 mg/L
Contaminant above legal limit 1 Jun 2020 Resolved/closed

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Milford

SiteTypeDistanceMedianSamplesYears
Silver Lake @ Maple Ave.
Delaware Dept Natural Resources &amp; Environmental Control
Riverine Impoundment 0.6 mi52 mg/L1992000–2025
Mullet Run at Rt. 14
Delaware Dept Natural Resources &amp; Environmental Control
River/Stream 0.7 mi54 mg/L182002–2005
MULLET RUN AT MILFORD, DE
USGS Maryland Water Science Center
Stream 0.7 mi48 mg/L12000
Middle of Silver Lake
Delaware Dept Natural Resources &amp; Environmental Control
Riverine Impoundment 0.8 mi43 mg/L182002–2005
Le55-09
USGS Maryland Water Science Center
Well 0.9 mi47 mg/L32000–2018
Haven Lake @ Rt. 113
Delaware Dept Natural Resources &amp; Environmental Control
Riverine Impoundment 1.2 mi44 mg/L532000–2008

Water hardness in towns near Milford

TownDistanceMedianClass
Dover18 mi 62 mg/LModerately hard
Smyrna28 mi 67 mg/LModerately hard
Middletown40 mi 68 mg/LModerately hard
Glasgow51 mi 76 mg/LModerately hard
Bear51 mi 85 mg/LModerately hard
Brookside54 mi 90 mg/LModerately hard
Newark56 mi 86 mg/LModerately hard
Wilmington57 mi 100 mg/LModerately hard
Pike Creek Valley59 mi 94 mg/LModerately hard
Hockessin62 mi 99 mg/LModerately hard

Kent County

Milford is in Kent County, where the median is 55 mg/L (soft) across 188 sites.

See all of Kent County →

Delaware

The statewide median is 53 mg/L (soft) from 823 sites.

Delaware hardness map →

Milford, DE water: common questions

Do I need a water softener in Milford?

Probably not. Water measured around Milford is 2.7 gpg (47 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →

Who supplies Milford's drinking water?

The main public water system serving Milford in EPA records is Milford Water Department. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Milford?

It depends on what you want to remove. In Milford, the system reports 3 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced; the system had 1 health-based violation since 2016, for Fluoride; the utility's annual report says what was done about it. On the other hand, no PFAS found in EPA testing. A water softener is not a filter.Check your own service line →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next