Water hardness in Naugatuck Valley Planning Region, CT

Water in Naugatuck Valley Planning Region is moderately hard, with a median of 90 mg/L (5.3 grains per gallon) across 65 monitoring sites.

30% harder than the Connecticut median (69 mg/L) 4th hardest of 9 counties
90mg/L
5.3 grains per gallon
Moderately hard

Naugatuck Valley Planning Region water at a glance

  • HardnessModerately hard (90 mg/L, 5.3 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 90 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.3 gpg (5 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites65
Lab samples1,024
Sample years2000–2023
Middle 50% of sites68–116 mg/L
Groundwater (wells, springs)88 mg/L · 54 sites
Surface water (rivers, lakes)98 mg/L · 11 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Naugatuck Valley Planning Region

Prefilled with Naugatuck Valley Planning Region's measured local hardness of 90 mg/L (5.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Naugatuck Valley Planning Region on the Connecticut map

Northeastern Connecticut Planning RegionCapitol Planning RegionGreater Bridgeport Planning RegionSoutheastern Connecticut Planning RegionLower Connecticut River Valley Planning RegionSouth Central Connecticut Planning RegionWestern Connecticut Planning RegionNorthwest Hills Planning Region

Cities and communities in Naugatuck Valley Planning Region

PlaceMedian mg/LClassBased on
Waterbury 87 Moderately hard 51 sites within 10 miles
Bristol 60 Soft 16 sites within 10 miles
Meriden 132 Hard 15 sites within 10 miles
Naugatuck 88 Moderately hard 50 sites within 10 miles
Ansonia 90 Moderately hard county median
Oakville (CDP) 86 Moderately hard 47 sites within 10 miles
New Milford (CDP) 71 Moderately hard 6 sites within 10 miles
Cheshire Village (CDP) 104 Moderately hard 14 sites within 10 miles
Terryville (CDP) 60 Soft 16 sites within 10 miles
Heritage Village (CDP) 86 Moderately hard 53 sites within 10 miles
Watertown (CDP) 86 Moderately hard 45 sites within 10 miles
Bethlehem Village (CDP) 85 Moderately hard 44 sites within 10 miles
Thomaston (CDP) 40 Soft 7 sites within 10 miles
Woodbury Center (CDP) 86 Moderately hard 51 sites within 10 miles
Bridgewater (CDP) 88 Moderately hard 50 sites within 10 miles
East Village (CDP) 103 Moderately hard 8 sites within 10 miles
Plantsville (CDP) 136 Hard 17 sites within 10 miles
Sandy Hook (CDP) 89 Moderately hard 49 sites within 10 miles

Water quality in Naugatuck Valley Planning Region communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Waterbury Waterbury Water Department None detected 952 lead · 0 unknown None
Bristol Bristol Water Department 2 found (PFOA 4.1 / PFOS ND ppt) 0 lead · 0 unknown None
Meriden Meriden Water Division 7 found (PFOA 6.1 / PFOS 9.5 ppt) 0 lead · 417 unknown 1
Naugatuck CTWC - Naugatuck Region-Central System None detected 1 lead · 5,977 unknown None
Ansonia Regional Water Authority 4 found (PFOA 7.1 / PFOS 10.7 ppt) 17 lead · 5,963 unknown None
New Milford Aquarion-New Milford Regional 5 found (PFOA 5.3 / PFOS 5.3 ppt) 0 lead · 5,052 unknown None
Cheshire Village Regional Water Authority 4 found (PFOA 7.1 / PFOS 10.7 ppt) 17 lead · 5,963 unknown None
Watertown Watertown Water & Sewer Authority None detected 0 lead · 933 unknown None
Bethlehem Village North Purchase Elderly Housing Not tested 0 lead · 0 unknown None
Thomaston CTWC - Naugatuck Reg-Thomaston System None detected 0 lead · 884 unknown None
Bridgewater Bridgewater Commons Condominiums Not tested 0 lead · 0 unknown None

Connecticut

The statewide median is 69 mg/L (moderately hard) from 192 sites.

Connecticut hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next