Water hardness in Bristol, CT
Water in Bristol is soft, with a median of 60 mg/L (3.5 grains per gallon) across 16 monitoring sites within 10 miles.
Bristol tap water at a glance
- HardnessSoft (60 mg/L, 3.5 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFAS2 found; the highest PFOA result was above EPA's 4 ppt limit (a single result is not a violation).Filters that remove PFAS →
- Lead pipesNo lead service lines reported.Details →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 60 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 3.5 gpg (3.4 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Bristol
Prefilled with Bristol's measured local hardness of 60 mg/L (3.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Bristol tap water
Bristol Water Department is the main public water system for Bristol. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 10 samples taken Sep 2023 – Jun 2024. 2 PFAS were detected. The highest PFOA result was above EPA's drinking water limit (4 ppt).
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFOA perfluorooctanoic acid | 4.1 ppt | 2 of 10 samples | 4 ppt |
| PFPeA perfluoropentanoic acid | 3.1 ppt | 1 of 10 samples | — |
Other water systems serving parts of Bristol
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| CTWC - Unionville System serves over 10,000 people | PFBA, PFOS, PFOA +3 more | 6 / 6 ppt | Mar 2023 – Dec 2023 |
| Valley Water Systems, INC. serves over 10,000 people | PFOS, PFBA, PFOA | 5.2 / 6.8 ppt | Feb 2023 – Aug 2023 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Bristol
Bristol Water Department reported 17,286 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
Other water systems serving parts of Bristol
| Water system | Service lines | Total |
|---|---|---|
| CTWC - Unionville System | 0 lead · 9 galvanized · 4,963 unknown | 6,670 |
| Aquarion-Plainville Regional | 6 lead · 141 galvanized · 5,409 unknown | 6,852 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Bristol drinking water violations
EPA records show no health-based violations for Bristol Water Department since 2016. It also had 15 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Bristol
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| CTWC - Unionville System | 2 | 1 |
| Valley Water Systems, INC. | 1 | 10 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Bristol
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| PEQUABUCK R AT FORESTVILLE, CT. USGS Connecticut Water Science Center | Stream | 2.2 mi | 92 mg/L | 9 | 2016 |
| CT- BS 277 USGS Connecticut Water Science Center | Well | 2.2 mi | 225 mg/L | 9 | 2003–2017 |
| CT- BU 145 USGS Connecticut Water Science Center | Well | 3.1 mi | 46 mg/L | 2 | 2003–2017 |
| CT- S 400 USGS Connecticut Water Science Center | Well | 4.5 mi | 18 mg/L | 1 | 2002 |
| CT- F 344 USGS Connecticut Water Science Center | Well | 4.9 mi | 349 mg/L | 1 | 2002 |
| CT- S 401 USGS Connecticut Water Science Center | Well | 4.9 mi | 200 mg/L | 1 | 2002 |
Water hardness in towns near Bristol
| Town | Distance | Median | Class |
|---|---|---|---|
| New Britain | 8 mi | 152 mg/L | Hard |
| Waterbury | 10 mi | 87 mg/L | Moderately hard |
| Newington | 11 mi | 152 mg/L | Hard |
| West Hartford | 11 mi | 94 mg/L | Moderately hard |
| Meriden | 13 mi | 132 mg/L | Hard |
| Wethersfield | 14 mi | 93 mg/L | Moderately hard |
| Torrington | 14 mi | 20 mg/L | Soft |
| Naugatuck | 15 mi | 88 mg/L | Moderately hard |
| Hartford | 15 mi | 94 mg/L | Moderately hard |
| Wallingford Center | 17 mi | 104 mg/L | Moderately hard |
Naugatuck Valley Planning Region
Bristol is in Naugatuck Valley Planning Region, where the median is 90 mg/L (moderately hard) across 65 sites.
See all of Naugatuck Valley Planning Region →Connecticut
The statewide median is 69 mg/L (moderately hard) from 192 sites.
Connecticut hardness map →Bristol, CT water: common questions
Do I need a water softener in Bristol?
Probably not. Water measured around Bristol is 3.5 gpg (60 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Bristol's drinking water?
The main public water system serving Bristol in EPA records is Bristol Water Department. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Bristol?
It depends on what you want to remove. In Bristol, EPA testing found PFOA and PFPeA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Which water filters remove PFAS?EPA tests found 2 PFAS in Bristol's main water system.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.