Water hardness in Santa Ana, CA

Water in Santa Ana is very hard, with a median of 322 mg/L (18.8 grains per gallon) across 65 monitoring sites within 10 miles.

104% harder than the California median (158 mg/L) 91st hardest of 484 California towns Population 310,539
322mg/L
18.8 grains per gallon
Very hard

Large city utilities sometimes soften, blend or import water from distant reservoirs, so tap water in Santa Ana can differ from local source water. Your utility's annual Consumer Confidence Report lists the exact tap value.

Santa Ana tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 322 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 18.8 gpg (18 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites65
Lab samples131
Sample years2000–2020
Middle 50% of sites222–381 mg/L
Groundwater (wells, springs)323 mg/L · 64 sites
Surface water (rivers, lakes)242 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Santa Ana

Prefilled with Santa Ana's measured local hardness of 322 mg/L (18.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Santa Ana tap water

City of Santa Ana is the main public water system for Santa Ana. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 28 samples taken Mar 2023 – Apr 2026. 5 PFAS were detected. The highest PFOS and PFOA results were above EPA's drinking water limit (4 ppt).

ChemicalHighest resultDetected inEPA limit
PFOS
perfluorooctane sulfonic acid
14.2 ppt 7 of 28 samples 4 ppt
PFOA
perfluorooctanoic acid
8.9 ppt 8 of 28 samples 4 ppt
PFHxS
perfluorohexane sulfonic acid
8.4 ppt 9 of 28 samples 10 ppt*
PFPeA
perfluoropentanoic acid
5.9 ppt 5 of 28 samples —
PFHxA
perfluorohexanoic acid
4 ppt 4 of 28 samples —

Other water systems serving parts of Santa Ana

Water systemPFAS detectedHighest PFOA / PFOSTested
Mesa Water District
serves over 10,000 people
None detected — Mar 2023 – Aug 2024
City of Orange
serves over 10,000 people
PFPeA, PFOS, PFBA +4 more 9.3 / 17 ppt Mar 2023 – Apr 2026
Irvine Ranch Water District
serves over 10,000 people
PFBA, PFPeA — Mar 2023 – Jul 2025
City of Tustin
serves over 10,000 people
PFOS, PFPeA, PFHxS ND / 4.2 ppt Mar 2023 – Nov 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Santa Ana

City of Santa Ana reported 45,753 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
45,753not lead (100%)

Other water systems serving parts of Santa Ana

Water systemService linesTotal
Mesa Water District0 lead · 0 galvanized · 0 unknown25,358
City of Orange0 lead · 0 galvanized · 0 unknown39,833
Irvine Ranch Water District0 lead · 0 galvanized · 0 unknown122,603
City of Tustin0 lead · 130 galvanized · 0 unknown14,136

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Santa Ana drinking water violations

EPA records show no health-based violations for City of Santa Ana since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Santa Ana

Water systemHealth-based violationsMonitoring/reporting
Mesa Water DistrictNone0
City of OrangeNone1
Irvine Ranch Water DistrictNone1
City of TustinNone3

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Santa Ana

SiteTypeDistanceMedianSamplesYears
005S009W19H001S
USGS California Water Science Center
Well 1.9 mi201 mg/L32009–2020
005S010W10K004S
USGS California Water Science Center
Well 1.9 mi390 mg/L12000
005S010W01E002S
USGS California Water Science Center
Well 2.2 mi364 mg/L12000
005S010W26Q003S
USGS California Water Science Center
Well 2.2 mi675 mg/L12000
005S010W01E003S
USGS California Water Science Center
Well 2.3 mi276 mg/L22009–2020
005S010W21B004S
USGS California Water Science Center
Well 2.5 mi196 mg/L82003–2020

Water hardness in towns near Santa Ana

TownDistanceMedianClass
Orange4 mi 326 mg/LVery hard
Tustin4 mi 328 mg/LVery hard
Fountain Valley4 mi 280 mg/LVery hard
Costa Mesa5 mi 310 mg/LVery hard
Garden Grove5 mi 238 mg/LVery hard
North Tustin5 mi 324 mg/LVery hard
Westminster6 mi 212 mg/LVery hard
Huntington Beach7 mi 276 mg/LVery hard
Irvine8 mi 276 mg/LVery hard
Stanton8 mi 213 mg/LVery hard

Orange County

Santa Ana is in Orange County, where the median is 304 mg/L (very hard) across 78 sites.

See all of Orange County →

California

The statewide median is 158 mg/L (hard) from 5,772 sites.

California hardness map →

Santa Ana, CA water: common questions

Do I need a water softener in Santa Ana?

Very likely. Water measured around Santa Ana is 18.8 gpg (322 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 33,000 grains.Size it for your household →

Who supplies Santa Ana's drinking water?

The main public water system serving Santa Ana in EPA records is City of Santa Ana. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Santa Ana?

It depends on what you want to remove. In Santa Ana, EPA testing found PFOS, PFOA and PFHxS and 2 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next