Water hardness in Kings County, CA
Water in Kings County is moderately hard, with a median of 82 mg/L (4.8 grains per gallon) across 39 monitoring sites.
Kings County water at a glance
- HardnessModerately hard (82 mg/L, 4.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 82 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.8 gpg (4.6 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Kings County
Prefilled with Kings County's measured local hardness of 82 mg/L (4.8 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Kings County on the California map
Cities and communities in Kings County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Hanford | 59 | Soft | 28 sites within 10 miles |
| Lemoore | 44 | Soft | 29 sites within 10 miles |
| Corcoran | 164 | Hard | 10 sites within 10 miles |
| Avenal | 149 | Hard | 7 sites within 10 miles |
| Lemoore Station (CDP) | 113 | Moderately hard | 12 sites within 10 miles |
| Armona (CDP) | 59 | Soft | 30 sites within 10 miles |
| Home Garden (CDP) | 40 | Soft | 25 sites within 10 miles |
| Kettleman City (CDP) | 112 | Moderately hard | 4 sites within 10 miles |
| Stratford (CDP) | 88 | Moderately hard | 10 sites within 10 miles |
| Grangeville (CDP) | 64 | Moderately hard | 29 sites within 10 miles |
| Hardwick (CDP) | 59 | Soft | 29 sites within 10 miles |
Water quality in Kings County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Hanford | City of Hanford | None detected | 0 lead · 0 unknown | 4 |
| Lemoore | City of Lemoore | None detected | 0 lead · 907 unknown | 39 |
| Corcoran | City of Corcoran | None detected | 0 lead · 0 unknown | None |
| Avenal | City of Avenal | None detected | Not reported | 9 (1 open) |
| Kettleman City | Kettleman City CSD | Not tested | 0 lead · 337 unknown | 22 (1 open) |
Neighboring counties
- Fresno County180 mg/L
- Tulare County154 mg/L
- San Luis Obispo County463 mg/L
- Madera County95 mg/L
- Kern County190 mg/L
- San Benito County267 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.