Water hardness in Alpine County, CA

Water in Alpine County is moderately hard, with a median of 104 mg/L (6.1 grains per gallon) across 7 monitoring sites.

34% softer than the California median (158 mg/L) 39th hardest of 58 counties
104mg/L
6.1 grains per gallon
Moderately hard

Alpine County water at a glance

  • HardnessModerately hard (104 mg/L, 6.1 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 104 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 6.1 gpg (5.8 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites7
Lab samples46
Sample years2000–2008
Middle 50% of sites65–171 mg/L
Groundwater (wells, springs)79 mg/L · 2 sites
Surface water (rivers, lakes)164 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Alpine County

Prefilled with Alpine County's measured local hardness of 104 mg/L (6.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Alpine County on the California map

Sierra CountySanta Barbara CountyNevada CountyLos Angeles CountySan Bernardino CountyRiverside CountyNapa CountyMarin CountySan Joaquin CountySanta Clara CountySiskiyou CountyEl Dorado CountyAlameda CountyTulare CountyKern CountyAmador CountySan Francisco CountyMonterey CountySan Benito CountySan Mateo CountyLassen CountyStanislaus CountyContra Costa CountyFresno CountyOrange CountyMariposa CountyColusa CountyInyo CountySacramento CountySan Luis Obispo CountyPlacer CountyMono CountyKings CountyMerced CountyMendocino CountySolano CountyDel Norte CountyYolo CountyMadera CountyPlumas CountyTuolumne CountyTrinity CountyImperial CountyTehama CountyCalaveras CountyButte CountyHumboldt CountyShasta CountySan Diego CountyYuba CountyLake CountyVentura CountyGlenn CountySanta Cruz CountyModoc CountySutter CountySonoma County

Cities and communities in Alpine County

PlaceMedian mg/LClassBased on
Markleeville (CDP) 104 Moderately hard 7 sites within 10 miles
Mesa Vista (CDP) 54 Soft 3 sites within 10 miles
Kirkwood (CDP) 22 Soft 4 sites within 10 miles
Bear Valley (CDP) 104 Moderately hard county median
Alpine Village (CDP) 104 Moderately hard 5 sites within 10 miles

Water quality in Alpine County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Markleeville Markleeville Water Co. Not tested 0 lead · 0 unknown None
Alpine Village Alpine Village Not tested 0 lead · 0 unknown 28

Neighboring counties

California

The statewide median is 158 mg/L (hard) from 5,772 sites.

California hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next