Water hardness in Hot Springs, AR
Water in Hot Springs is soft, with a median of 26 mg/L (1.5 grains per gallon) across 62 monitoring sites within 10 miles.
Hot Springs tap water at a glance
- HardnessSoft (26 mg/L, 1.5 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo known lead lines; 28,032 lines are still of unknown material.Check your own pipe →
- Violations1 health-based violation since 2016.What they were →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 26 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.5 gpg (1.5 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Hot Springs
Prefilled with Hot Springs's measured local hardness of 26 mg/L (1.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Hot Springs tap water
Hot Springs Utilities is the main public water system for Hot Springs. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Feb 2023 – Nov 2023. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Hot Springs
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Kimzey Regional Water District serves over 10,000 people | None detected | — | May 2024 – Feb 2025 |
| Hot Springs Village Waterworks serves over 10,000 people | None detected | — | Dec 2023 – Sep 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Hot Springs
Hot Springs Utilities reported 39,399 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 28,032 lines are still of unknown material.
Other water systems serving parts of Hot Springs
| Water system | Service lines | Total |
|---|---|---|
| Kimzey Regional Water District | 0 lead · 0 galvanized · 0 unknown | 4,492 |
| Hot Springs Village Waterworks | 0 lead · 0 galvanized · 3,735 unknown | 9,996 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Hot Springs drinking water violations
EPA records show 1 health-based violation for Hot Springs Utilities since 2016, all since resolved or closed. The most recent began in Jan 2019. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
| Contaminant or rule | Type | Violations | Most recent | Status |
|---|---|---|---|---|
| Total trihalomethanes (TTHM) byproducts formed when chlorine reacts with natural matter in water · what it means highest measured 87 UG/L; limit 0.080 mg/L | Contaminant above legal limit | 1 | Jan 2019 | Resolved/closed |
Other water systems serving parts of Hot Springs
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Kimzey Regional Water District | None | 0 |
| Hot Springs Village Waterworks | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Hot Springs
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| Quapaw Spring USGS Arkansas Water Science Center | Spring | 1.7 mi | 133 mg/L | 1 | 2007 |
| Fordyce Spr. 46 in Fordyce Bath House @ HOSP N.P. USGS Arkansas Water Science Center | Spring | 1.7 mi | 134 mg/L | 1 | 2007 |
| Superior Spr. in Superior Bath House @ HOSP N.P. USGS Arkansas Water Science Center | Spring | 1.7 mi | 133 mg/L | 1 | 2007 |
| Hale Spr. in Hale Bath House @ HOSP N.P. USGS Arkansas Water Science Center | Spring | 1.7 mi | 133 mg/L | 1 | 2007 |
| Spring 49 @ HOSP N.P. USGS Arkansas Water Science Center | Spring | 1.8 mi | 131 mg/L | 1 | 2007 |
| Spring 9 @ HOSP N.P. USGS Arkansas Water Science Center | Spring | 1.8 mi | 132 mg/L | 1 | 2007 |
Water hardness in towns near Hot Springs
| Town | Distance | Median | Class |
|---|---|---|---|
| Hot Springs Village | 13 mi | 19 mg/L | Soft |
| Malvern | 15 mi | 23 mg/L | Soft |
| Arkadelphia | 25 mi | 16 mg/L | Soft |
| Benton | 28 mi | 53 mg/L | Soft |
| Bryant | 33 mi | 58 mg/L | Soft |
| Little Rock | 43 mi | 40 mg/L | Soft |
| Maumelle | 45 mi | 27 mg/L | Soft |
| North Little Rock | 51 mi | 38 mg/L | Soft |
| Conway | 52 mi | 62 mg/L | Moderately hard |
| Sherwood | 54 mi | 28 mg/L | Soft |
Garland County
Hot Springs is in Garland County, where the median is 32 mg/L (soft) across 68 sites.
See all of Garland County →Hot Springs, AR water: common questions
Do I need a water softener in Hot Springs?
Probably not. Water measured around Hot Springs is 1.5 gpg (26 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Hot Springs's drinking water?
The main public water system serving Hot Springs in EPA records is Hot Springs Utilities. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Hot Springs?
It depends on what you want to remove. In Hot Springs, the system had 1 health-based violation since 2016, for TTHM; the utility's annual report says what was done about it. On the other hand, no PFAS found in EPA testing and no lead service lines reported. A water softener is not a filter.How to read your water quality report →
Hardness scale
What to read next
- How to tell if your home has a lead pipe28,032 service lines here are of unknown material.
- TTHM in drinking waterDisinfection byproducts appear in this system's violation record.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.