Water hardness in Troy, AL

Water in Troy is soft, with a median of 35 mg/L (2.1 grains per gallon) across 7 monitoring sites within 10 miles.

about the same as the Alabama median (45 mg/L) 50th hardest of 69 Alabama towns Population 17,836
35mg/L
2.1 grains per gallon
Soft

Troy tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 35 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 2.1 gpg (2 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites7
Lab samples86
Sample years2004–2024
Middle 50% of sites19–76 mg/L
Surface water (rivers, lakes)35 mg/L · 7 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Troy

Prefilled with Troy's measured local hardness of 35 mg/L (2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Troy tap water

Troy Utilities (City of) is the main public water system for Troy. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 9 samples taken Jul 2024 – Jan 2025. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Troy

Water systemPFAS detectedHighest PFOA / PFOSTested
Pike County Water Authority
serves over 10,000 people
6:2 FTS — Aug 2023 – Aug 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Troy

City of Troy Utilities reported 4,940 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 51 are galvanized lines that must be replaced, and 38 are still of unknown material.

0lead (0%)
51galvanized requiring replacement
38unknown material (<1%)
4,851not lead (98%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Troy Utilities whether your address is on its list.

Other water systems serving parts of Troy

Water systemService linesTotal
Pike County Water Authority0 lead · 20 galvanized · 6 unknown2,375

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Troy drinking water violations

EPA records show no health-based violations for Troy Utilities (City of) since 2016. It also had 29 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Troy

Water systemHealth-based violationsMonitoring/reporting
Pike County Water AuthorityNone56

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Troy

SiteTypeDistanceMedianSamplesYears
WCP-1
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 3.4 mi35 mg/L292006–2024
WCP-1A
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 3.5 mi90 mg/L312006–2024
BIGP-1A
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 4.5 mi61 mg/L42004–2008
BMNP-1
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 5.3 mi14 mg/L12004
WCP-3
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 5.7 mi97 mg/L122006–2017
BMNP-2
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 7.3 mi22 mg/L42014

Water hardness in towns near Troy

TownDistanceMedianClass
Ozark31 mi 19 mg/LSoft
Enterprise34 mi 24 mg/LSoft
Pike Road34 mi 45 mg/LSoft
Montgomery42 mi 33 mg/LSoft
Eufaula48 mi 24 mg/LSoft
Dothan51 mi 44 mg/LSoft
Prattville53 mi 33 mg/LSoft
Millbrook54 mi 33 mg/LSoft
Auburn62 mi 44 mg/LSoft
Opelika69 mi 46 mg/LSoft

Pike County

Troy is in Pike County, where the median is 24 mg/L (soft) across 12 sites.

See all of Pike County →

Alabama

The statewide median is 45 mg/L (soft) from 2,227 sites.

Alabama hardness map →

Troy, AL water: common questions

Do I need a water softener in Troy?

Probably not. Water measured around Troy is 2.1 gpg (35 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →

Who supplies Troy's drinking water?

The main public water system serving Troy in EPA records is Troy Utilities (City of). Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Troy?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next