Water hardness in Millbrook, AL
Water in Millbrook is soft, with a median of 33 mg/L (1.9 grains per gallon) across 33 monitoring sites within 10 miles.
Millbrook tap water at a glance
- HardnessSoft (33 mg/L, 1.9 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFAS7 found; the highest PFOS and PFOA result was above EPA's 4 ppt limit (a single result is not a violation).Filters that remove PFAS →
- Lead pipesNo lead service lines reported.Details →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 33 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.9 gpg (1.8 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Millbrook
Prefilled with Millbrook's measured local hardness of 33 mg/L (1.9 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Millbrook tap water
Millbrook Utilities is the main public water system for Millbrook. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 6 samples taken Jan 2025 – Oct 2025. 7 PFAS were detected. The highest PFOS and PFOA results were above EPA's drinking water limit (4 ppt).
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFBS perfluorobutane sulfonic acid | 65 ppt | 5 of 6 samples | — |
| PFPeA perfluoropentanoic acid | 23.2 ppt | 5 of 6 samples | — |
| PFOS perfluorooctane sulfonic acid | 18.1 ppt | 5 of 6 samples | 4 ppt |
| PFOA perfluorooctanoic acid | 15.2 ppt | 5 of 6 samples | 4 ppt |
| PFHxA perfluorohexanoic acid | 15.1 ppt | 5 of 6 samples | — |
| PFBA perfluorobutanoic acid | 9.2 ppt | 5 of 6 samples | — |
| PFHpA perfluoroheptanoic acid | 5.9 ppt | 5 of 6 samples | — |
Other water systems serving parts of Millbrook
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Elmore Water & Sewer Authority serves over 10,000 people | None detected | — | Jan 2023 – Oct 2023 |
| Prattville (Water Works Board of) serves over 10,000 people | PFBS, PFPeA, PFOS +4 more | 19.2 / 22.8 ppt | Aug 2024 – Mar 2026 |
| Tri Community Water System serves over 10,000 people | PFBS, PFPeA, PFOS +4 more | 19 / 19 ppt | Nov 2024 – Aug 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Millbrook
Millbrook Utilities reported 1,820 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
Other water systems serving parts of Millbrook
| Water system | Service lines | Total |
|---|---|---|
| Elmore Water & Sewer Authority | 0 lead · 0 galvanized · 9 unknown | 5,329 |
| City of Prattville, the WW Board of the | 0 lead · 284 galvanized · 33 unknown | 18,018 |
| Tri Community Water System | 0 lead · 773 galvanized · 1 unknown | 4,458 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Millbrook drinking water violations
EPA records show no health-based violations for Millbrook Utilities since 2016. It also had 54 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Millbrook
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Elmore Water & Sewer Authority | None | 1 |
| Prattville (Water Works Board of) | None | 149 |
| Tri Community Water System | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Millbrook
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| MILE-1 ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA | River/Stream | 3.2 mi | 10 mg/L | 10 | 2005–2020 |
| MRC-2 ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA | River/Stream | 4 mi | 11 mg/L | 11 | 2018–2026 |
| Well NAWQA LUSCR1-25 Elmore Cnty AL USGS Alabama Water Science Center | Well | 4.7 mi | 14 mg/L | 1 | 2001 |
| WDFA-3 ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA | Reservoir | 5 mi | 42 mg/L | 41 | 2000–2023 |
| PINA-2 ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA | River/Stream | 5.3 mi | 17 mg/L | 5 | 2018 |
| Well NAWQA LUSCR1-30 Montgomery Cnty AL USGS Alabama Water Science Center | Well | 5.5 mi | 38 mg/L | 1 | 2001 |
Water hardness in towns near Millbrook
| Town | Distance | Median | Class |
|---|---|---|---|
| Prattville | 6 mi | 33 mg/L | Soft |
| Montgomery | 12 mi | 33 mg/L | Soft |
| Pike Road | 22 mi | 45 mg/L | Soft |
| Alexander City | 38 mi | 12 mg/L | Soft |
| Selma | 39 mi | 33 mg/L | Soft |
| Sylacauga | 48 mi | 108 mg/L | Moderately hard |
| Calera | 48 mi | 160 mg/L | Hard |
| Auburn | 52 mi | 44 mg/L | Soft |
| Troy | 54 mi | 35 mg/L | Soft |
| Alabaster | 56 mi | 155 mg/L | Hard |
Elmore County
Millbrook is in Elmore County, where the median is 17 mg/L (soft) across 43 sites.
See all of Elmore County →Millbrook, AL water: common questions
Do I need a water softener in Millbrook?
Probably not. Water measured around Millbrook is 1.9 gpg (33 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Millbrook's drinking water?
The main public water system serving Millbrook in EPA records is Millbrook Utilities. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Millbrook?
It depends on what you want to remove. In Millbrook, EPA testing found PFBS, PFPeA and PFOS and 4 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Which water filters remove PFAS?EPA tests found 7 PFAS in Millbrook's main water system.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.