Water hardness in Battle Ground, WA

Water in Battle Ground is soft, with a median of 41 mg/L (2.4 grains per gallon) across 5 monitoring sites within 10 miles.

45% softer than the Washington median (74 mg/L) 103rd hardest of 122 Washington towns Population 22,285
41mg/L
2.4 grains per gallon
Soft

Battle Ground tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 41 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 2.4 gpg (2.3 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites5
Lab samples44
Sample years2015–2015
Middle 50% of sites19–66 mg/L
Surface water (rivers, lakes)41 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Battle Ground

Prefilled with Battle Ground's measured local hardness of 41 mg/L (2.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Battle Ground tap water

City of Battle Ground Water Dept is the main public water system for Battle Ground. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 5 samples taken Mar 2026. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Battle Ground

Water systemPFAS detectedHighest PFOA / PFOSTested
Clark Public Utilities
serves over 10,000 people
PFOS, PFOA, PFHxS +2 more 8 / 8.4 ppt Mar 2023 – Sep 2023

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Battle Ground

City of Battle Ground Water Dept reported 6,955 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 585 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
585unknown material (8%)
6,370not lead (92%)

Other water systems serving parts of Battle Ground

Water systemService linesTotal
Clark Public UtilitiesNot reported—

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Battle Ground drinking water violations

EPA records show no health-based violations for City of Battle Ground Water Dept since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Battle Ground

Water systemHealth-based violationsMonitoring/reporting
Clark Public UtilitiesNone1

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Battle Ground

SiteTypeDistanceMedianSamplesYears
WEAVER CR AT SE MERRITT DR, NR BATTLE GROUND, WA
USGS Oregon Water Science Center
Stream 1.2 mi41 mg/L102015
ROCK CREEK NEAR BATTLE GROUND, WA
USGS Oregon Water Science Center
Stream 5.2 mi19 mg/L102015
SALMON CREEK AT NE 199TH ST, NR VENERSBORG, WA
USGS Oregon Water Science Center
Stream 5.3 mi18 mg/L42015
WHIPPLE CREEK NEAR SALMON CREEK, WA
USGS Oregon Water Science Center
Stream 8.6 mi96 mg/L102015
GEE CREEK AT ABRAMS PARK, AT RIDGEFIELD, WA
USGS Oregon Water Science Center
Stream 9.9 mi66 mg/L102015

Water hardness in towns near Battle Ground

TownDistanceMedianClass
Orchards6 mi 64 mg/LModerately hard
Five Corners6 mi 61 mg/LModerately hard
Salmon Creek7 mi 66 mg/LModerately hard
Ridgefield8 mi 53 mg/LSoft
Hazel Dell8 mi 74 mg/LModerately hard
Vancouver10 mi 74 mg/LModerately hard
Camas13 mi 51 mg/LSoft
Washougal16 mi 51 mg/LSoft
Kelso29 mi 16 mg/LSoft
Longview33 mi 16 mg/LSoft

Clark County

Battle Ground is in Clark County, where the median is 51 mg/L (soft) across 8 sites.

See all of Clark County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Battle Ground, WA water: common questions

Do I need a water softener in Battle Ground?

Probably not. Water measured around Battle Ground is 2.4 gpg (41 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →

Who supplies Battle Ground's drinking water?

The main public water system serving Battle Ground in EPA records is City of Battle Ground Water Dept. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Battle Ground?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next