Water hardness in Alpine, UT

Water in Alpine is very hard, with a median of 221 mg/L (12.9 grains per gallon) across 109 monitoring sites within 10 miles.

14% softer than the Utah median (256 mg/L) 56th hardest of 67 Utah towns Population 10,298
221mg/L
12.9 grains per gallon
Very hard

Alpine tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 221 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 12.9 gpg (12.4 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites109
Lab samples1,091
Sample years2000–2021
Middle 50% of sites146–354 mg/L
Groundwater (wells, springs)246 mg/L · 59 sites
Surface water (rivers, lakes)163 mg/L · 50 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Alpine

Prefilled with Alpine's measured local hardness of 221 mg/L (12.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Alpine tap water

Alpine City is the main public water system for Alpine. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 2 samples taken Mar 2025 – Sep 2025. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Alpine

Alpine City reported 3,203 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 575 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
575unknown material (18%)
2,628not lead (82%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Alpine drinking water violations

EPA records show no health-based violations for Alpine City since 2016.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Alpine

SiteTypeDistanceMedianSamplesYears
CHIPMAN CK (ALPINE UT) BL USFS BOUNDARY
Utah Department Of Environmental Quality
River/Stream 1.4 mi18 mg/L142002–2012
(D- 4- 2)30cdc- 1
USGS Utah Water Science Center
Well 1.6 mi221 mg/L12003
Dry Ck ab CNFL/ Chipman Ck (Alpine)
Utah Department Of Environmental Quality
River/Stream 1.9 mi66 mg/L262006–2012
(D- 4- 2)31abd- 1
USGS Utah Water Science Center
Well 2.2 mi242 mg/L12003
(D- 4- 1)36bcb- 1
USGS Utah Water Science Center
Well 2.4 mi228 mg/L12003
AMERICAN FORK RIVER AT MOUTH OF CANYON
Utah Department Of Environmental Quality
River/Stream 2.4 mi227 mg/L232000–2005

Water hardness in towns near Alpine

TownDistanceMedianClass
Highland3 mi 248 mg/LVery hard
Draper5 mi 316 mg/LVery hard
American Fork6 mi 253 mg/LVery hard
Lehi6 mi 343 mg/LVery hard
Pleasant Grove7 mi 233 mg/LVery hard
Sandy9 mi 349 mg/LVery hard
Lindon9 mi 241 mg/LVery hard
Bluffdale9 mi 366 mg/LVery hard
Cottonwood Heights11 mi 346 mg/LVery hard
Riverton11 mi 414 mg/LVery hard

Utah County

Alpine is in Utah County, where the median is 250 mg/L (very hard) across 267 sites.

See all of Utah County →

Utah

The statewide median is 256 mg/L (very hard) from 4,077 sites.

Utah hardness map →

Alpine, UT water: common questions

Do I need a water softener in Alpine?

Very likely. Water measured around Alpine is 12.9 gpg (221 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 23,000 grains.Size it for your household →

Who supplies Alpine's drinking water?

The main public water system serving Alpine in EPA records is Alpine City. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Alpine?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next