Water hardness in Hurst, TX

Water in Hurst is very hard, with a median of 189 mg/L (11 grains per gallon) across 12 monitoring sites within 10 miles.

about the same as the Texas median (194 mg/L) 113th hardest of 251 Texas towns Population 39,304
189mg/L
11 grains per gallon
Very hard

Hurst tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 189 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 11 gpg (10.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites12
Lab samples209
Sample years2000–2006
Middle 50% of sites164–227 mg/L
Surface water (rivers, lakes)189 mg/L · 12 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Hurst

Prefilled with Hurst's measured local hardness of 189 mg/L (11.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Hurst tap water

City of Hurst is the main public water system for Hurst. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 10 samples taken May 2023 – Jul 2024. 3 PFAS were detected.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
6.3 ppt 8 of 10 samples —
PFPeA
perfluoropentanoic acid
3.9 ppt 7 of 10 samples —
PFHxA
perfluorohexanoic acid
3.2 ppt 4 of 10 samples —

Other water systems serving parts of Hurst

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Fort Worth
serves over 10,000 people
PFHxS, PFHxA, PFBA +4 more 8.3 / 7.3 ppt Jan 2023 – Jan 2024
City of Bedford
serves over 10,000 people
PFBA, PFBS, PFPeA +2 more ND / 4.3 ppt Jun 2024 – Mar 2025
City of Euless
serves over 10,000 people
PFBA, PFPeA, PFHxA +1 more — Jan 2023 – Aug 2024
City of North Richland Hills
serves over 10,000 people
PFHxS, PFBA, PFHxA +4 more 4.2 / 4.2 ppt Jan 2024 – Oct 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Hurst

City of Hurst reported 12,161 service lines (the pipes connecting homes to the water main) in its inventory. 2 are lead and 681 are galvanized lines that must be replaced, and 1,302 are still of unknown material.

2lead (<1%)
681galvanized requiring replacement
1,302unknown material (11%)
10,176not lead (84%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Hurst whether your address is on its list.

Other water systems serving parts of Hurst

Water systemService linesTotal
City of Fort Worth0 lead · 32,590 galvanized · 0 unknown300,778
City of Bedford0 lead · 0 galvanized · 0 unknown15,302
City of Euless0 lead · 45 galvanized · 653 unknown13,154
City of North Richland Hills0 lead · 0 galvanized · 13,611 unknown24,004

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Hurst drinking water violations

EPA records show no health-based violations for City of Hurst since 2016.

Other water systems serving parts of Hurst

Water systemHealth-based violationsMonitoring/reporting
City of Fort Worth11
City of BedfordNone0
City of EulessNone1
City of North Richland HillsNone3

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Hurst

SiteTypeDistanceMedianSamplesYears
WEST FORK TRINITY AT EAST 1ST
Texas Commission on Environmental Quality
River/Stream 7.1 mi154 mg/L72002
RUSH CREEK AT SH 180
Texas Commission on Environmental Quality
River/Stream 7.3 mi248 mg/L202000–2006
RUSH CREEK UPSTREAM OF SH 180
Texas Commission on Environmental Quality
River/Stream 7.5 mi308 mg/L12000
LAKE ARLINGTON SITE AC
Texas Commission on Environmental Quality
Reservoir 8.3 mi100 mg/L62002
Lk Arlington Site AC at Arlington, TX
USGS Texas Water Science Center
Lake, Reservoir, Impoundment 8.3 mi106 mg/L182000–2002
WEST FORK TRINITY AT GATEWAY
Texas Commission on Environmental Quality
River/Stream 8.3 mi170 mg/L372003–2006

Water hardness in towns near Hurst

TownDistanceMedianClass
Bedford3 mi 190 mg/LVery hard
North Richland Hills3 mi 168 mg/LHard
Colleyville4 mi 140 mg/LHard
Watauga5 mi 168 mg/LHard
Haltom City5 mi 110 mg/LModerately hard
Euless6 mi 184 mg/LVery hard
Keller7 mi 138 mg/LHard
Southlake8 mi 138 mg/LHard
Grapevine9 mi 147 mg/LHard
Arlington10 mi 160 mg/LHard

Tarrant County

Hurst is in Tarrant County, where the median is 355 mg/L (very hard) across 59 sites.

See all of Tarrant County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Hurst, TX water: common questions

Do I need a water softener in Hurst?

Very likely. Water measured around Hurst is 11 gpg (189 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 19,000 grains.Size it for your household →

Who supplies Hurst's drinking water?

The main public water system serving Hurst in EPA records is City of Hurst. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Hurst?

It depends on what you want to remove. In Hurst, EPA testing found PFBA, PFPeA and PFHxA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system reports 2 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next