Water hardness in Bedford, TX

Water in Bedford is very hard, with a median of 190 mg/L (11.1 grains per gallon) across 27 monitoring sites within 10 miles.

about the same as the Texas median (194 mg/L) 111th hardest of 251 Texas towns Population 48,370
190mg/L
11.1 grains per gallon
Very hard

Bedford tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 190 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 11.1 gpg (10.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites27
Lab samples1,105
Sample years2000–2023
Middle 50% of sites138–241 mg/L
Groundwater (wells, springs)11 mg/L · 1 sites
Surface water (rivers, lakes)191 mg/L · 26 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Bedford

Prefilled with Bedford's measured local hardness of 190 mg/L (11.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Bedford tap water

City of Bedford is the main public water system for Bedford. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 10 samples taken Jun 2024 – Mar 2025. 5 PFAS were detected. The highest PFOS result was above EPA's drinking water limit (4 ppt).

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
9 ppt 8 of 10 samples —
PFBS
perfluorobutane sulfonic acid
4.6 ppt 8 of 10 samples —
PFPeA
perfluoropentanoic acid
4.4 ppt 8 of 10 samples —
PFOS
perfluorooctane sulfonic acid
4.3 ppt 2 of 10 samples 4 ppt
PFHxA
perfluorohexanoic acid
3.9 ppt 8 of 10 samples —

Other water systems serving parts of Bedford

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Euless
serves over 10,000 people
PFBA, PFPeA, PFHxA +1 more — Jan 2023 – Aug 2024
City of Fort Worth
serves over 10,000 people
PFHxS, PFHxA, PFBA +4 more 8.3 / 7.3 ppt Jan 2023 – Jan 2024
City of Grapevine
serves over 10,000 people
PFHxA, PFPeA, PFBA +4 more 5.5 / 5 ppt Feb 2023 – Nov 2023
City of Hurst
serves over 10,000 people
PFBA, PFPeA, PFHxA — May 2023 – Jul 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Bedford

City of Bedford reported 15,302 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
15,302not lead (100%)

Other water systems serving parts of Bedford

Water systemService linesTotal
City of Euless0 lead · 45 galvanized · 653 unknown13,154
City of Fort Worth0 lead · 32,590 galvanized · 0 unknown300,778
City of Grapevine0 lead · 7 galvanized · 0 unknown15,355
City of Hurst2 lead · 681 galvanized · 1,302 unknown12,161

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Bedford drinking water violations

EPA records show no health-based violations for City of Bedford since 2016.

Other water systems serving parts of Bedford

Water systemHealth-based violationsMonitoring/reporting
City of EulessNone1
City of Fort Worth11
City of GrapevineNone2
City of HurstNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Bedford

SiteTypeDistanceMedianSamplesYears
BEAR CREEK AT COUNTY LINE ROAD
Texas Commission on Environmental Quality
River/Stream 6.2 mi220 mg/L242002–2004
BEAR CREEK AT COUNTY LINE RD
Texas Commission on Environmental Quality
River/Stream 6.2 mi186 mg/L22005–2006
BEAR CREEK AT VALLEY VIEW LN
Texas Commission on Environmental Quality
River/Stream 6.5 mi254 mg/L182001–2006
ESTELLE CREEK UPSTRM PIONEER DR
Texas Commission on Environmental Quality
River/Stream 6.7 mi192 mg/L302001–2004
JOHNSON CREEK AT SH 360
Texas Commission on Environmental Quality
River/Stream 7.1 mi210 mg/L232000–2006
RUSH CREEK AT SH 180
Texas Commission on Environmental Quality
River/Stream 8.1 mi248 mg/L202000–2006

Water hardness in towns near Bedford

TownDistanceMedianClass
Hurst3 mi 189 mg/LVery hard
Colleyville3 mi 140 mg/LHard
Euless3 mi 184 mg/LVery hard
North Richland Hills5 mi 168 mg/LHard
Watauga7 mi 168 mg/LHard
Grapevine7 mi 147 mg/LHard
Southlake8 mi 138 mg/LHard
Keller8 mi 138 mg/LHard
Haltom City8 mi 110 mg/LModerately hard
Irving10 mi 174 mg/LHard

Tarrant County

Bedford is in Tarrant County, where the median is 355 mg/L (very hard) across 59 sites.

See all of Tarrant County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Bedford, TX water: common questions

Do I need a water softener in Bedford?

Very likely. Water measured around Bedford is 11.1 gpg (190 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 20,000 grains.Size it for your household →

Who supplies Bedford's drinking water?

The main public water system serving Bedford in EPA records is City of Bedford. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Bedford?

It depends on what you want to remove. In Bedford, EPA testing found PFBA, PFBS and PFPeA and 2 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next