Water hardness in Canby, OR
Water in Canby is moderately hard, with a median of 67 mg/L (3.9 grains per gallon) across 56 monitoring sites within 10 miles.
Canby tap water at a glance
- HardnessModerately hard (67 mg/L, 3.9 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo lead service lines reported.Details →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 67 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 3.9 gpg (3.8 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Canby
Prefilled with Canby's measured local hardness of 67 mg/L (3.9 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Canby tap water
Canby Utility is the main public water system for Canby. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Sep 2023 – Apr 2024. No PFAS were found at or above EPA's minimum reporting levels.
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Canby
Canby Utility reported 6,109 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Canby drinking water violations
EPA records show no health-based violations for Canby Utility since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Canby
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| Molalla River at Knights Bridge Road (Canby) Department of Environmental Quality - State of Oregon | River/Stream | 1.1 mi | 20 mg/L | 52 | 2000–2024 |
| Molalla River at Canby-Marquam Hwy (Goods Bridge) Department of Environmental Quality - State of Oregon | River/Stream | 1.4 mi | 15 mg/L | 6 | 2007–2008 |
| Mid Willamette Groundwater Study Well MWV-071 Department of Environmental Quality - State of Oregon | Well | 2.2 mi | 129 mg/L | 1 | 2017 |
| Willamette River at Hebb Park Boat Ramp Department of Environmental Quality - State of Oregon | River/Stream | 2.2 mi | 26 mg/L | 29 | 2004–2024 |
| Willamette River at Canby Ferry Department of Environmental Quality - State of Oregon | River/Stream | 2.4 mi | 24 mg/L | 46 | 2000–2024 |
| Molalla River at River Mile 0.2 Department of Environmental Quality - State of Oregon | River/Stream | 2.7 mi | 37 mg/L | 3 | 2004–2005 |
Water hardness in towns near Canby
| Town | Distance | Median | Class |
|---|---|---|---|
| Wilsonville | 5 mi | 66 mg/L | Moderately hard |
| Oregon City | 7 mi | 56 mg/L | Soft |
| West Linn | 7 mi | 56 mg/L | Soft |
| Tualatin | 9 mi | 61 mg/L | Moderately hard |
| Molalla | 9 mi | 82 mg/L | Moderately hard |
| Gladstone | 10 mi | 54 mg/L | Soft |
| Sherwood | 10 mi | 64 mg/L | Moderately hard |
| Lake Oswego | 10 mi | 57 mg/L | Soft |
| Oak Grove | 11 mi | 54 mg/L | Soft |
| Oatfield | 11 mi | 54 mg/L | Soft |
Clackamas County
Canby is in Clackamas County, where the median is 23 mg/L (soft) across 96 sites.
See all of Clackamas County →Canby, OR water: common questions
Do I need a water softener in Canby?
Probably not. Water measured around Canby is 3.9 gpg (67 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 7,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →
Who supplies Canby's drinking water?
The main public water system serving Canby in EPA records is Canby Utility. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Canby?
Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.