Water hardness in Molalla, OR

Water in Molalla is moderately hard, with a median of 82 mg/L (4.8 grains per gallon) across 26 monitoring sites within 10 miles.

15% harder than the Oregon median (71 mg/L) 22nd hardest of 67 Oregon towns Population 10,103
82mg/L
4.8 grains per gallon
Moderately hard

Molalla tap water at a glance

  • HardnessModerately hard (82 mg/L, 4.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 82 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 4.8 gpg (4.6 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites26
Lab samples106
Sample years2000–2024
Middle 50% of sites40–127 mg/L
Groundwater (wells, springs)111 mg/L · 21 sites
Surface water (rivers, lakes)19 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Molalla

Prefilled with Molalla's measured local hardness of 82 mg/L (4.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Molalla tap water

City of Molalla is the main public water system for Molalla. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jan 2023 – Oct 2023. 1 PFAS was detected.

ChemicalHighest resultDetected inEPA limit
6:2 FTS
6:2 fluorotelomer sulfonic acid
11.3 ppt 1 of 4 samples —

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Molalla

City of Molalla reported 2,927 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
2,927not lead (100%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Molalla drinking water violations

EPA records show no health-based violations for City of Molalla since 2016. It also had 3 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Molalla

SiteTypeDistanceMedianSamplesYears
Mid Willamette Groundwater Study Well MWV-093
Department of Environmental Quality - State of Oregon
Well 0.7 mi38 mg/L12017
05S/02E-07AAC
USGS Oregon Water Science Center
Well 1.1 mi73 mg/L12002
Mid Willamette Groundwater Study Well MWV-054
Department of Environmental Quality - State of Oregon
Well 1.7 mi248 mg/L12017
Mid Willamette Groundwater Study Well MWV-069
Department of Environmental Quality - State of Oregon
Well 2.2 mi43 mg/L12017
Mid Willamette Groundwater Study Well MWV-070
Department of Environmental Quality - State of Oregon
Well 3.2 mi66 mg/L12017
Mid Willamette Groundwater Study Well MWV-092
Department of Environmental Quality - State of Oregon
Well 3.6 mi131 mg/L12017

Water hardness in towns near Molalla

TownDistanceMedianClass
Canby9 mi 67 mg/LModerately hard
Oregon City13 mi 56 mg/LSoft
Woodburn13 mi 125 mg/LHard
Silverton14 mi 96 mg/LModerately hard
Wilsonville14 mi 66 mg/LModerately hard
West Linn15 mi 56 mg/LSoft
Gladstone16 mi 54 mg/LSoft
Oatfield18 mi 54 mg/LSoft
Tualatin18 mi 61 mg/LModerately hard
Oak Grove18 mi 54 mg/LSoft

Clackamas County

Molalla is in Clackamas County, where the median is 23 mg/L (soft) across 96 sites.

See all of Clackamas County →

Oregon

The statewide median is 71 mg/L (moderately hard) from 2,142 sites.

Oregon hardness map →

Molalla, OR water: common questions

Do I need a water softener in Molalla?

Probably not. Water measured around Molalla is 4.8 gpg (82 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 9,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Molalla's drinking water?

The main public water system serving Molalla in EPA records is City of Molalla. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Molalla?

It depends on what you want to remove. In Molalla, EPA testing found 6:2 FTS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next