Water hardness in Wagoner County, OK
Water in Wagoner County is moderately hard, with a median of 112 mg/L (6.6 grains per gallon) across 8 monitoring sites.
Wagoner County water at a glance
- HardnessModerately hard (112 mg/L, 6.6 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 112 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 6.6 gpg (6.3 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Wagoner County
Prefilled with Wagoner County's measured local hardness of 112 mg/L (6.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Wagoner County on the Oklahoma map
Cities and communities in Wagoner County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Coweta | 112 | Moderately hard | county median |
| Wagoner | 112 | Moderately hard | 8 sites within 10 miles |
| Porter | 124 | Hard | 3 sites within 10 miles |
| Okay | 126 | Hard | 14 sites within 10 miles |
| Tullahassee | 158 | Hard | 3 sites within 10 miles |
| Redbird | 163 | Hard | 3 sites within 10 miles |
| Clarksville (CDP) | 152 | Hard | 8 sites within 10 miles |
| Mallard Bay (CDP) | 114 | Moderately hard | 13 sites within 10 miles |
| Rocky Point (CDP) | 112 | Moderately hard | 10 sites within 10 miles |
| Taylor Ferry (CDP) | 108 | Moderately hard | 12 sites within 10 miles |
| Toppers (CDP) | 108 | Moderately hard | 12 sites within 10 miles |
| Whitehorn Cove (CDP) | 108 | Moderately hard | 12 sites within 10 miles |
Water quality in Wagoner County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Coweta | Coweta | 4 found | 0 lead · 1,334 unknown | 42 |
| Wagoner | Wagoner | None detected | Not reported | 1 |
| Tullahassee | Tullahassee Water | Not tested | Not reported | 44 (1 open) |
Neighboring counties
- Muskogee County140 mg/L
- Tulsa County152 mg/L
- Mayes County102 mg/L
- Rogers County118 mg/L
- Cherokee County96 mg/L
- Okmulgee County166 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.